I'm just wrapping up my 2 barrel to 4 barrel conversion on a 73 318.
I got a Edlebrock AVS 2. (fired up right away)
I'm looking for suggestions on a good fuel line connection as the edelbrock line is a 6an thread and the dart fuel line is 5/16 the dodge threads are a smaller diameter
Thanks
I bought a new timing chain cover and I thought I had the right one as the timing marks lined up on the drivers side but as it turns out the new opening for the crank shaft is larger than the original, will it still work ? or am I better off getting another one that is the same size opening as...
I picked up a Edlebrock rubber 9266 intake gasket
to ensure I don't have heat issues between the AVS 2 carb and my stock 73 340 intake manifold.
The wider spaced gasket holes are made for the edlebrock performer intake but there is room to punch new holes to line up with the narrower factory...
when installing the new urethane bushing do I need to remove the metal ring?
I don't think it would fit if I leave it in place.
I remove the original rubber bushing already.
And thoughts on this is appreciated.
I'm finally getting closer to the completion of my almost stock 68 Dart convertible, I've been out of the street rod mechanical side for a few years.
I'm looking for recommendations for a street cruiser set up, the original 318 block had been replaced with a 73 LA 318 it has a mild cam in it...
I want to change the inner and outer wheelhouse (quarter panel wheel-wells) from auto metal direct on my 68 dart convertible. I know they are not the same as the hardtop version but I want to know if I cut about the top 1/4 will it fit? That looks like what they did for the factory fit. If...
I am Looking for good plastic 68 gt body side molding trim clips large and small,
I have never found any re manufactured versions if anyone knows where
I can find a set for both sides it would be very appreciated. As they get old they get brittle and break.
Thanks
I have a lot of old undercoating to remove so I would like to hear your suggestions on what did and didn't work.
I know a guy that swears by using dried ice
you put it in a tray under your car near the undercoating and it gets so cold it shrinks and flakes off!!!
I've owned this dart for about 15 years when I bought it I new
the owner had done a hack job on it but since this was the same color
and year as my 1st hard top dart and was a v8 convertible it seemed like
fate. I drove it fixing up a little here and there always having it ready for
summertime...
I'm looking for a set of new pressed bolts that attach the front of the
leaf spring hanger to the frame of a 68 dart, they look like stud Bolts for a wheel rim except they only take a 3/8 nut it is 1 1/2 inches long. If anyone knows where I can get these on line it would be appreciated.
The...
Wow great site, I finally found a group to share my misery with !
just kidding I wouldn't trade my mopar away. I'm in year two of
a severe rustoration the last guy butchered a lot. Lots of fabricating
so its inspiring to read every ones stories
I've had my 68 dart convertible for almost 20 years and although
there are production for all darts or GTS darts over all these years
I have never found any for convertibles.
So I'm putting this out to you,If any one has any numbers I would
appreciate it my convertible is a GT with 318 but...
I'm looking for a timing chain cover for my 68 small block
I understand they changed the timing marks after 69,
I'm looking for one in very good condition
Thanks