It’s possible. I just did mine a couple weeks ago. Driver side, had to replace lifters. Not hard, plenty of room, removing headers sucked. Installing sucked even more; but it can be done, get a flex ratcheting wrench, and you’re good to go.
Yea the hotel is right across the street. Area seems nice and quite. Shelby is a deadend street, so not much traffic around, it’s an Comfort Inn.
There is also another hotel down the street, Hotel d’Lins. Like Autoxcuda said, there’s an airport near by, there’s a few hotels.
Yea, I’m worried about that, May put more along the top, or switch sides. hard to plan for that when I don’t have one swap pre-registered yet. Final decision will be April 1..
With the more accurate count, I can get a better layout.
I got it from google, that’s what I’ve been working with. He did give me laminated sheet, killer specs on on the property, and that will help a lot.
Good guy. He knows his stuff.
not finalized yet, but here’s a rough draft.
I’ll do my best at having every one in and out smoothly.
Participants will enter in the middle, far left entry for spectators. Exit is far left.
swappers can get in and set up an hour early, gates open at 7, show starts at 8..
Lots of land for...
...Training Center
3250 E Shelby St
Ontario, CA 91764
United States
PDF included
Online Pre-registration opens soon
Directions:
From the east:
* Westbound on I-10, exit on Haven Avenue
* Turn right onto Haven Avenue at the bottom of the offramp
* North on Haven Avenue to Inland Empire Blvd.
*...
Thanks!
Yeah that’s the plan is to have the seats covered to match. Was trying to make it to a car show, MATS, but it was cancelled. So there’s a few things I’ll go back over.
So with running the carbs, it takes away all the electronics for efi away. MSD box, MSD Hemi6 runs the coils. It connects to the coils, cam sensor and crank sensor. Then that’s pretty much it. It’s hooked to a old school 4 speed, so none there.
Thank you. Can’t wait to get her out and bang some gears. It’ll be fun to work out any kinks and make any changes while being able to actually drive it.
Finally finished her up...
at least that’s what the wife believes
Still need to order up some exhaust, still open headers at the moment. Also need to mess with the air/fuel settings. Still having some issues with getting her to idle. Also the fan temp switch didn’t come on at the stated...
Rear seat is stock. Front seats are out of a 2014 Dodge Challenger. Even ran some power to have a power seat. mean power to the console, to power the trunk opener, hurst line lock, and usb plug for a charger.