I asked this question last week and wasn't precise enough with the info. I received several answers and questions to my question. The post dropped off without me seeing the answer I needed......so I will ask again. What is the distance between the faces of the front leaf spring mount to the...
Thanks, Fred. I was very careful taking them out. I will repair them and use them if I can't find any. There is extensive rust damage in several areas but they can be restored.
Just a short update on the 440. The motor started after a little bit of timing tweaking. Let it run for just a few seconds as it wasn't hooked up to a radiator. Good oil pressure. Great throttle response. Thanks for the advice on how to wire it in.
Not starting the engine yet. Just wanted to be sure of oil pressure before the start. The 5/16 hexshaft run counter clockwise in my cordless drill bottomed out the pressure gauge. Oil pump works fine.
Getting ready to start my 440 before putting it in the Dart. A couple of questions for you expert Moparians. 1. Do the plugs need to be installed to test? 2. What pressure/pressures should I be looking for?
Thanks a bunch!
Hello fellow Moparians. I couple years back I remember a post showing how to modify a steering column with shifter to one without. I don't seem to be able to find it now that I am ready to do mine. They cut the offending pieces off and filled with epoxy (or something else), sanded and...
It has electronic ignition distributor and box, both Mallory. I was going to put a "points" distributor in for the test run as I am not certain the box is good.
I'm looking to test run my 440 before installing. Anyone have a wiring diagram on how it needs to be wired in order to do this? I've watched several videos on you tube but they are vague in details. Thanks.
Meant to ask you before......what did you do about the screw holes for the clips? Did the urethane seal them or did you weld them before doing the windshield and rear window?