Search results for query: *

This was the inexpensive, low quality hose that I just discarded. Thanks for posting, but I'd recommend against using this product.

Could very well be a bad repop.

I'll take them. Send me a message with how you want to be paid.

Scam

You did this from an iPhone? All that comes up in share is airdrop, messages, mail and news.

2" over stock rear sprngs from Espo

factory 65~72 for small bolt pattern or 73~76 for big bolt pattern will give you front disc, rear drums. there are also some aftermarket front kits that will fit a 14" if you're looking for rear discs that will fit with a 14" rim, i'm not sure such a beast exists.

What can I do to make my car have this stance without going to air shocks?

Correct diameter hose is also available from Nappa. https://www.napacanada.com/en/p/UNR23840?srsltid=AfmBOorZkf0XXUXjYsMxdGoStWqrbZHun18_i88sihgDMk0bBmyNiEMy Here's the Nappa Part Numbers for my American friends.. https://www.napaonline.com/en/p/NOE96004...

What was

certainly appreciated, I don't remember any instructions with the struts but I think the proprietor was very approachable. Kinda wish they still did individual suspension parts. Im kinda partial to the old Mopar front end and spring config. Additionally, YouTube is full of folks doing front...

I have a 72 Dart 318 with 4 wheel manual drum brakes on 14" wheels. I want to convert to disk brakes. I would like to replace front and back and add vacuum booster. Everything I've found says I have to convert to 15" wheels. Is there a disk brake replacement for 14" wheels anywhere out there?

Welcome from West Virginia……….. :thumbsup:

I suspect Dana's point was that there should be no voltage drop with the key on or off unless something besides the ignition and field are drawing power. Voltage drop only occurs when current meets resistance. Key on with a normal ignition and field should draw no more than 5 amps. The...

Shipping would be about $20

They are offshore sourced like all after market rods these days. The bearing bore and pin bore measured good. They weigh 705 grams. I ran about 30 1/8 mile passed on them. They were just a bit too heavy to balance my crank without using Mallory metal.

Yup. Some days suck harder than others but you can't quit. I can't quit anyway. If I just sit around I'll lose my mind (what's left of it) and my body will lock up. I'd rather be dead than live like that.

Pics of car

Hi All: I just posted the latest chapter to my component restoration series under the title "Bob's Component Resto, Chapter 37: The Defroster Hoses". You can find it under "Member Restorations" in the forums section. I've come up with an affordable solution to replacing those old rotten factory...

Someone is always worse off than you and me, so I’ve decided to stop whining, push as hard as I can and empathize with those truly worse off than me.

Hey Pittsburgh, what do you think of those Trickflows? The Mopar ones.

NICE------AND-----SUBTLE!!!

Hello MoBros and MoSis'. I trust all is well with you and that you've been sleeping well of late. If not, I'd like to present my latest component resto chapter: the defroster hoses. Guaranteed to put you to sleep! So let's get right into it. Is there a single member of the Mopar...

Weather Channel now should say "Trash programming crying about climate change"

Hi I received an email if i entered my Vin Number i could get more info about my Dart ,now i cant find it .Any help .Thanks

The bypass valve is in the oil pump.

Fords, have you seen their connecting rods lol

I'd buy them.