Search results for query: *

I have a 65 Cuda in my barn I can look at tomorrow, I believe it non-remote and a twin post but I'll double check.

Ok do u have Zelle

$125 shipped

I have for sale a bunch of Master cylinder adapters I made. They are made from 6061-T6 aluminum.These have a bore of 1.725 to allow for the wilwood master cylinder and the "Chrysler style" plastic reservoir.These are 4.25" by 3.25". They are slightly bigger than the other guys so they cover the...

I remember the uglt torquer thread, you worked a little magic. Do you have any experience with the small block strip dominator.

Well I don kno zackly what they sniff for, but it worked fo me on mo dan one occashun :lol:

3.91 gears are a good balance of ratio and MPH, but the tire size will play into your 1/4 mile time. I run those gears with a 365 4spd and found that a 26" tire is a handy cap for mph. 3.55 gear ratio pulls a better mph by 3.5 mph but a 1/3 second slower et.

It's hot! Or a head gasket

Probably Methane. :poke::rofl:

:rofl:

Get it sniffed with the meter to see if there exhaust gas in there.

Cut the patties and freeze them on a cookie sheet and wax paper. Then bag em' and back in the freezer.

That's my problem, Poppen and farting. Think I need a new thermostat or my head is leaking past my gasket.

This thread has largely been focused on “tactical” things rather than “strategic “ things. If we were to back up a little bit and take a wider look, I would ask what your goals are? Short term income? Long term income? Capital appreciation? Exit strategy? If you are going to get what you...

I was a little surprised by the old Torquer small block intake I ported. “Ugly Torquer post) for my son. Hopefully I can replace it with an M1.

Unscrew the small plug. Remove the spring and detent ball with a magnet. Then take the housing out. Nothing holding the ball in the housing.

Nice patina