Search results for query: *

21 mpg

Now, 10678 miles on this setup without problem 44 run 1/4 mile drag race 12 run 1/8 mile drag race

My headlight kit: http://www.amazon.com/Round-Diamond-Sealed-Headlights-Conversion/dp/B005FHM6NW

Real S.U.V. :finga:

I dont have dust shield

3.23 Rear end and a-833 overdrive

:happy1: Demon swap 5.7 hemi drag 1/4 hemi swap drag - YouTube

Read this : A warning about spark tables The new Hemis neither need nor appreciate a lot of timing advance. We've found that 22 degrees at full throttle is all the advance one is likely to need on race gas, and can be too much on pump gas. The default MS3 timing table is for an older...

My Wheel , Front: 18X8.0 offset 25 255/40 R18 General Tire Challenger 1974 Front disk brake Tubular A-arm with big ball joint Small modification of fender Rear: 18X9.0 offset 25 275/40 R18 General Tire 8.75 rear end from B-body 62-70(track 59.2)relocate perches to 43" 0.250" cutting lip of...

Stock Msd

No power steering and no air mustang chassis Dyno sheet

My Wheel , Front: 18X8.0 offset 25 255/40 R18 General Tire Challenger 1974 Front disk brake Tubular A-arm with big ball joint Small modification of fender Rear: 18X9.0 offset 25 275/40 R18 General Tire 8.75 rear end from B-body 62-70(track 59.2)relocate perches to 43" 0.250" cutting lip of...

Hi, Final picture of my hemi swap project. Weight 3120 LB Front tire 255/40-18 Rear tire 275/40-18 Rear suspension Hotchkis Performance 24385 :happy1:

Check list of my swap Hemi. Hemi 5.7 2005 with A-833 Home made parts: -Intake -headers -Transmission support slot by .500 -Input shaft shorted by .750 -Catch can for coolant -Accelerator cable support -busching for pulley serpentine belt -shorted spark plug wire Buy parts: -MSD ignition...

Very easy, Open the clamp with screw driver and hammer, (coil pack side) 1-Cut the wire at the good long 2-Cut the black and blue outside wire, do not touch the black fiber at the center of wire .Keep one inch . 3-Turn the center wire to the outside and clamp. I reuse the old clamp...

I did it myself.:finga: I cut the original dodge ram long wires.

Thanks ! Oil pan come from Ebay Mopar crate engine Motor mounts come from TTI Part number for the serpentine belt is K070673

I have 2500 miles on this set-up . Today, I went to chassis dyno. :happy1: Hemi swap dyno - YouTube

I bought the pistol grip in car show. He was not expensive, because he had already been modified. I made a part for bottom of pistol grip with a 3/8 plate of steel. Then, I have painting flat black.

More picture of my project I'd like to give more details about the pictures But I'm a french canadian and my english is bad.:sad10: If you have questions send it. And I am going to try to answer it. Thanks

Dodge Demon 1971 Hemi 5.7 truck 2005 Homemade intake Homemade headers MSD Hemi 6 AED 650 carburator Stock A-833 4 speed Stock Z-bar Stock torsion bar YouTube - hemi swap