Search results for query: *

i just got the new alt and sent the new style square back. My old system had the 2 wires. I dont really care what alt is on as long as it works and not rigged. The square back has 3 wire hook up. If i read other replys correctly i would need to ground one of connections to make work?

I took alternator to have tested. They said it was bad. Will rebuild this one and see what happens

Picture now

Ok car has been completely restored paint engine and all. I parked car for little while and my battery died. I replaced battery and was fine drove car all day no issues. Went to dinner with wife and dead battery. The car is no longer charging. I did same as i did last time. Changed vr and still...

I pulled the wire harness apart and traced all the wires. Pulled one fuse at time removed both door switches. Touched the light housing in back pannel...click lights go off. Simple wire on housing was grounding out. Lesson learned K.I.S.S now need to clean it all back up. Thanks for help

Yes i took wire harness out and fixed wires that were bad. Im confused on why it works then shorts out little later.

Thanks for help it was working fine before i painted car. No delayed light before. Looking for diagram of yellow n pink wire

But light turns on and off just fine. No delay goes back on by its self hour later

I dont recall seeing that. Only thing close is turn signal relay by ashtray

What does it look like? Just strange the light works with doors then after little bit the lights stay on

I disconnect both switches and lights stay on.

68 barracuda

My interior lights are driving me crazy. The lights seem to work with door switches. I can open doors they go on close they go off. About hour later i look my lights are on. Open door close door they stay on. Only way to turn off is disconnect battery. Then door switch works again. Then starts...

250.00

Big block 727 with stall. 1800 mi on rebuild. Stall was around 1700 600 obo

Came from 68 barracuda 340 $50 zbar $40 clutch fork + shipping

Threads are perfect no cracks. Was behind 340 $250.00 obo

73 340 4 speed. Complete engine and trans. J heads Pulled from 68 barracuda. Asking 3000.00 for complete set up

I think it quit because bolt was loose on vr? The alternator i think was shot. Hardly any resistance when you spin it. Came with car so im slowly working all the bugs out. Has all new qa1 suspension rearend and clutch. Original paint from California. Rust you see is all surface.

Rockauto got solid state from orillys. Like the look of old one better

I purchased a new VR and good to go. 13-14v. Thanks for help

Looks like it arc on cover. And no i didnt see what fell out.

I just pulled VR off. I can hear something rattling inside. Possible to high voltage going in?

I did not have this problem until i changed VR. Im going to try grounding it again.

Ok just dove back into it. I ran jumper to starter relay to green wire from vr and it was charging. I jumped two wires from vr together and was charging. Key in on poss ign to pos battery it red .60

Thanks for help will need to dive back in tomorrow.

I jumped green wire from vr to battery and was charging

Ive had car for about year and not sure what was done. It was working fine for the last year or so. Everything looks stock for most part. It has electronic mallery distributor

If i run lights heater or any accessories volts drop to 11.50 and keeps going down.