Search results for query: *

Hey all, I have an a body heater/Air box, can anyone tell me what wires goes to the resistor card and the where the 2 wires from the blower motor go? THanks, Eric

2002 Dodge Ram, 4.7. THe radio does not work at all, interior lights won't work, power locks, neither head lights, everything is dead unless I turn the truck on, I checked all the fuses and seems that they are good, I did replac the 20 amp fuse in slot 51 as with the other (2) 20 amp fuses for...

http://www.forabodiesonly.com/mopar/showthread.php?t=109462 Ok...I started the thread above because I had a major electrical melt down on my way home from Carlisle. I removed the windsheild, then the dash as a whole because I felt it would be easier to see the extent of the damage as the...

Just curious if anyone had tried this. My red wire is melted, the amp gauge is brown (white face overlayed), the light bulb socket is melted and the circuit board is discolored. http://www.madelectrical.com/electricaltech/amp-gauges.shtml...

On my way back from Carlisle the Ammeter in my 73 Dart was pegged, turning brown (I have white face overlays) and smoke had emitted from the gauge. I had it roll-backed home and now have the windshield out, and pulled the dash frame so I could examine the harness easier as a whole. I found...

Not sure if this should be here or in Heating/ac so I'll put it in both... Is the blower control switch the same from 73 to 74? I see Rock Auto offers for 74 but not 73 on down. It also looks like there is 4 spade pins on the 73 where my 73 has 3. Thanks, Eric

73 Dart, w/360, MSD coil and box. Have a new (remanned) alternator (55 amp) and new voltage regulator both from NAPA. With engine warm and idling, turn the lights on, and they dim badly, give it some gas and they brighten up. The amp meter in the cluster is down to about negative 10. Anyone...

OK... I got a Mancini Distributor (non adjustable vacuum advance). I wanted to be able to FINE tune my timing so I replaced the non adjustable with an adjustable. When I started my Dart, I got a big 'pop', not like a back fire. I disconnected the vacuum line to the distrib and restarted...

Can anyone tell me, since my dash harness is out right now, if the cigar lighter is constant hot or is it energized when the key is turned?

I'm trying to wrap up everything on the car so I can fire it up. I keep blowing the 20 amp fuse in socket 4 of the fuse block, as soon as i hook up the battery it sparks and blows the fuse. My father-in-law and i removed the gauge cluster, and upon doing this it stopped. Held the connectors...

When I started ripping the Dart apart I didn't document or photograph where my negative battery ran to. Can anyone tell me where the large and small cable bolts to? or even a pic if ya got one? I think the small one bolted to the engine though. thanks guys! Eric

OK, I know there have been a few people to ask questions about hooking up their MSD box. I have the orange and black wires running to the coil. The white wire is to run to the old (-) wire for the coin, now the small red is suppose to run to switched power, is this the old (+) coil wire...

I'm getting close to starting the car, I'm finishing up the fuel lines. I have a Holley electrical pumpand I need switched power for my pump and some gauges. Where is a good source for switched power? What wire/fuse, where?

I'm putting the wiring harness back into the Dart (73). And I need a little guidance, there is a yellow wire with a connector near the starter relay, can anyone tell me where it goes or what it's for? Thanks guys, Eric