Search results for query: *

I always thought Harland Sharpe was a real good quality roller rocker. I just heard they were bought out and became junk. Anyone recently buy these?

Anyone using these heads? 318/340/360 or Magnum? Issues? What Rockers are you using? Performance? Are there accessory holes in heads (drilled and tapped)? I currently have an LA motor with the factory stock magnum heads. Was going to go with the 318/340/360 heads but relation of mine...

Can anyone tell me the engine RPM for a 360 in 72-74? Thanks...Eric

I have a 73 Swinger with a 360/727 and TTI headers. I'm having a difficult time getting the oil filter off, VERY hard to turn. Has anyone else encountered this problem? Has anyone else used the 90* adapter?

Got a question... How can you tell how much has been milled off of a head. I bought mine from a reman company. After I got them I called to find out how much they take off and they could not tell me. They were not even milled flat, I had to have an additional .010 milled to get them flat...

OK...OK, this maybe a REALLLLY dumb question, but! got the car warmed up, disconnected the vacuum advance and set the timing to 15*; hooked up the vacuum advance again and it jumped to 35*. Is this normal?

I built a 360, retrofitted the magnum heads on an LA block following the articles from Mopar Muscle and Ma Mopar. Using all the parts from Mopar including lifters and pushrods. Now I have the engine running and there is a 'tick' noise that circulates through the valve covers, and about 80% of...

I have a 360 with a high volume oil pump. While it was running I pulled the dipstick and there was nothing very little on the stick. It's a fresh oil change with 5 quarts of Rotella T 15W40 and a K&N oil filter and a stock oil pan with a windage tray. Would it hurt to add, say a half quart of...

This may sound like a dumb question, I have a comp cams xe268 cam, non-adjustable vacuum advance distributor from Mancini. When the rpm goes up, should vacuum go up or down?

Can anyone give mt the timing setting for a 360? Thanks, Eric

Can anyone give me the torque spec for the intake for the Magnum engines. I'm using a Professional products intake, I thought I read somewhere that it was 20 ft lbs, but that doesn't sound quite right. Can anyone give me the correct spec. Eric

360 Small Block, I want to install a windage tray and I have a few ?'s. I have 4 long bolts, 4 short bolts, and 8 flat washers. Do I use 2 washers under each long bolt, one under each bolt, etc.? What do I torque the short bolts to? I got no information with it, and can't find anything...

OK, I’m going back to my previous question, and expanding on it. Had a thought (look out!) The 300/360 crate has a cam spec of 250/264 with .385/.401 lift roller cam. The 360 I built has a 268/276 with .429/.444 flat tappet. The crate has a 9:1 CR while mine has a 9.6:1 CR. MPP suggests a...

I am currently working on a 1973 Dodge Dart Swinger. I have replaced the 318/904/7.25 with a 360/727/8.75 combo. This car is really for my enjoyment, not for big shows or drag. Basically just street driving and an occasional country drive; I live by a mountain so I would have to drive over...

I'm posting this in this forum and the General Discussion forum, hoping to find who wrote this: I just have a few questions because what I'm building is similar. Thanks guys "I just built a 360 with magnum heads. It's has zero deck KB107 flat top pistons, and 0.039 head gasket which results...