Search results for query: *

just got Jason’s car on the road for shakedown runs. Everything went very well. But, the part throttle shift points are a little high. Here’s the rundown on the combo. 1983 318, 214/224, 444/466, 104 installed intake centerline camshaft. Holley street dominator intake with 390 Holley vac...

strange issue with our rebuilt TF727. At first it engaged and drove up and down the driveway perfect. Today I was making some carb adjustments, and backed it outside to mess with it. It’s running great. But. When I went to pull it back in, I put it in gear, gave it some gas, and that’s...

Hard to describe in the title. 318/727 combo in a 1963 Valiant. Holley street dominator intake Holley vacuum sec 4150 Lokar throttle and kickdown cables Kickdown is properly adjusted, (at the first sign of tension at idle, and about 1/8" from full open at full throttle) No tight bends in...

727 transmission. Long (6.75"?) slip yoke. To seat into the axle requires us to pull the yoke 1.75" out of the tailshaft. Is this safe? In the past I've only had them out an inch or so. Thanks. Eric L

When tearing down our 727 for inspection, we discovered a "wave" steel in the middle of the clutch pack. My buddy that has rebuilt a handful of transmissions said that he's never seen that and that we should ask around about it. Is that normal? Does the rebuild kits come with the wavy...

Were currently rebuilding the 727 for our 63 valiant build. And I started searching for the correct gear for our setup. 3.73 gear. 245/60/15 tire (26.57). Falls around 37 tooth on the charts I've found. Where's a good place to purchase? We currently have a 30 tooth. Thanks. Eric and Jason

We are getting ready to pull apart and inspect the 727 for my sons project car we're building. We're hoping not to find any surprises. But we're ready for anything. Lol. In the past we have used trans go products with great success. We are looking at the stage 2 trans go kit currently. Any...

I know there's places that converts the cables. What does it cost? What parts are required? The car is going to be a street car with a mild 318. I just figured before I spent $200-$300 on an aftermarket shifter, I'd weigh my options. Thanks, Eric L