Search results for query: *

I recently had the trans on my 71 Duster 225ci out of the vehicle and decided to adjust the bands because I wasn't getting the best shifts. I adjusted the bands to the service manual specs (kickdown=72 in-lbs/back off 2 turns and low/reverse=72 in-lbs/back off 3 1/4 turns). I noticed the...

Does anyone know where to find various size thrust washers for the side gears in an 8 3/4 rear end?

I have a 1971 Plymouth Duster with a 225 and 904 and when I put the trans is gear (park or drive), there is a loud metallic clunk the the vehicle kinda jumps. I checked the u-joints and trans mount and they are all fine. Any ideas? Thanks.

I'm rebuilding a 727 and am to the point where I am checking the servos for leaks with air pressure and it seems like the low/reverse servo applies much harder than the kickdown servo. Is this normal? I've replaced the sealing rings and checked their fit and they were fine. Any suggestions? Thanks.

I am looking for an output shaft seal, the one that seals the inside of the drive shaft yoke and sits on the output shaft not the one that is pressed into the extension housing. I've checked multiple online sources but came up with nothing. Can anyone help me? Thanks.

What is the correct fluid type for a '66 727? I thought I read somewhere that it was ATF but I'm not sure. Thanks.

I am planning on rebuilding a 727 from a 66 Dodge and was wondering what the bushing sizes were. Thanks.

I have an 8 3/4 housing with a bent stud that attaches the third member to the housing and am having trouble locating a new one. Does anyone know where these can be purchased? Thank you.

8 1/4 or 7 1/4? How can you tell from the exterior? Thanks.

Does anyone know what size U-joint is in a 1971 Duster with a 225ci slant six and 904 trans? The reason I ask is because I recently built an 8 3/4 rearend for it with a pinion yoke for a 1350 u-joint. Thanks.

Was wondering if the 727 and 904 transmissions are the same length. The reason I ask is because I was planning on swapping a 727 in place of a 904 and wanted to know if I would need a different length driveshaft. Thanks.