Search results for query: *

i recently had an oil leak after changing my intake( the one i had machined to fit) i thought it was valve cover gasket so i changed them. seemed like i still had the leak so I pulled the valve cover and checked the intake bolts and plus the seal each end of the intake and the line for the...

intake bolts on a RPM Air Gap ?? the ones that were in my holley intake are to short and after reading reviews on other (even edlebrock) bolts seem to be to short. Im sure I can go buy some at the hardware store but thought i would check in to see first. Thanks Don

i have researched some and see that many people have issues with fitment even with stock applications as far as deck height and head surfaces. some night remember when i bought this 1985 360 i did not know much about it because it came already built. It came with a new gasket set so i decided...

ok so i have (that came with my motor) the Mopar performance valve covers (working on the matching air cleaner) and on one side is the oil cap to add oil and the other side is two Moroso breathers and no hole for the PVC valve. It looks like i could figure out a way to knock out a spot for a...

i got this intake along with a Holley carb and then decided to use a different intake and was just wondering if its any good and should i save it for another project thanks

first thanks in advance. oiling ( hallow)straight through type)or non oiling ( hollow through with solid ends) I have done some research on here and see that either will work fine with no real adverse effect on the valve train or oil pressures on pretty much normal daily street driven stock...

so when i put the tired 318 ( just to get a v-8 in it) i knew it was a short timer and was tired and used some oil. Well it was terrible and leaked ( under load)all over the header and smoked behind the car and in it as well at times. it did not always do it and was not always that bad. I did...

the one marked 360 is one i bought off here for the 360 to go in my 70 dart with a318 currently with a k-frame (spool type) out of a 74 factory v-8 dart the other is the one that came on the 360 i bought but really not sure what the motor came out of but was told a 74 charger. if...

got irons in the fire but picked up this 360 was supposedly rebuilt 1000 or so miles ago and last ran 6 or so months ago. Kid said got it from a old family friend that has no contact with anymore and no info on the specs. But at the end of the day i dont really care about all that as i got a...

a stock 1973 360( with j-heads) and it is complete minus the intake and carb. i got an intake and carb at a car show last summer and not sure if the carb is going to be good rebuild or junk. the intake says torker 340 on it and thats about all i know at this time as it is at a buddies house...

i searched some but not seem to come up with what im looking for so thanks in advance for any help and my bad if its been covered. doing valve seals in my worn out but runs great 1969 318. the ones on the heads are all the umbrella type that fit down snug over the top of the guide. the new ones...

i have two perfectly good running 318s one is a 1969 and the other is a 1974. i got the 69 out of a 70 pickup but then found the 74 complete factory v-8 car. I planned on just pulling the complete setup out of the 74 and dropping it in my 70 swinger but then somebody said the 69 motor would be...