Search results for query: *

  1. 1

    small block port centerline dimensions

    Does anyone happen to know or have a general idea of the head port centerline differences aprox (floor+roof average length to valve) for a standard edelbrock rpm or magnum vs indy 360-1 or victor style head. thanks
  3. 1

    360 la vs 360 magnum rear main seal diameter?

    Hi I ordered a stroker kit for a 98 magnum block and was asked to measure the rear main diameter. I thought the 360 la and magnum should be identical? I don’t have my motor out yet so I can’t measure. Anyone have any experience or input? I did hear that the 318 magnums may be .01 smaller but...
  4. 1

    Small block oil mod/pump

    Getting ready to start new stroker build soon. I’m using a 98 magnum block and eddy magnum heads with hydraulic roller. Looking to shift no higher then 6800. Motor will have a vacuum pump pulling around 12. Should I look into any oil mods and which oil pump should I go with? Used the high...
  5. 1

    1 7/8 headman hustler small block headers

    Any body use these on a duster? How did you like them? I might be looking to get a set
  6. 1

    edelbrock magnum head flow?

    So i have a set of edelbrock magnums that were fully ported, valve job, 2.05 intake valves...and flow about 290cfm at .600. What could i expect to gain if i ran an offset rocker and eliminated the pushrod pinch? is hughes the only ones who make the offset rockers for this setup? how about...
  8. 1

    Guess my horsepower/et

    new combo I’m gonna run soon. 360 magnum block stock bores, icon standard weight forged flat tops. It’s 10.7 to 1 compression. Stock rods with arp bolts, stock crank, Mopar performance windage tray, Edelbrock magnum heads flowing 295 at .600 with 2.05 valves. Hydraulic roller 239/247 at 50 .600...
  9. 1

    5.9 magnum in duster results!!

    Hi guys i know there are a few here with these engines that run well. heres the run down on the car. 98 Jeep magnum motor- said to have 55,000 miles Edelbrock intake with an old 650 we rebuilt Stock rockers Longer pushrods to take up the slack from the reground cam...searched through summit...
  10. 1

    5.9 magnum duster help..318 cam into 5.9 n convertor

    ok i have a couple of questions for those of you who have expierence with the 5.9 magnum motor. i have a 5.9 98 jeep motor thats going into my 76 duster. the car has been lightened so it will not be that heavy hopefully 3200-3300 lbs. i also plan on putting full caltracs suspension. car has a...
Back
Top