Search results for query: *

Looking for a Jig that's used in cutting a rear housing. To the best of my knowledge there is a lug that slips into the ends you are putting on and also two lugs that are fastened down by tightening the bearing cap bolts at the center section. These 4 lugs have a hole drilled in the center to...

Looking at a slant six Demon that has the factory 3 speed in the floor so all the pedals and such are in place. My questions to the more knowledgeable is this. If i were to consider, which i am, changing to a 4 speed what problems, if any, will i run into? Will the same bellhousing work? Is the...

I just bought a 3/4 ton conversion van that has a 9.25 under it. Not sure if it's a peg leg or SG at this time. Do these 9.25's have any value and are they desireable fo any of our cars or street trucks? Lots of other stuff on it like disc brakes, OD tranny. Curious about the rear end value...

WE'll be needing a tranny built for this 12 sec or less /6 car the group is building and we need some ideas as to what we need for a build. Give us you opinion on a tranny build. Do we have any good performance tranny builder as members of this site? Will a built 904 handle the power? I think so...

I've got a 67 Valiant 100 2 dr post and it came with a 3 speed on the column. I will be going back with a 727 auto so what is needed to make the brake pedal swap? I know this is different as everyone wants to go the other way.....and i could go the 4 speed route but am looking at the auto trail...

I drug the 67 post valiant in today and am having many thoughts on which way to go so here comes the questions. I would like to have rear meats of at least 10-12" wide. Do i need a narrowed rear to put on these wider tires? I plan on doing a mini tube if i need to. I guess i'll have to do a...

Never done one myself but have the books and starting on getting the tools the book calls for but am curious on how long one should allow for the build including disassembly and cleaning and reassembly for a 727 or 904? If it were only a day i would find someone close to me and travel to assist...

Rebuilt tranny, used TC 2800-3200 . Just cranked the motor last week and all systems seemed to be ok. Filled tranny with fluid as much as would take then cranked her up and dropped it in neutral to fill the TC ( per tranny builder)then shut it down and refilled tranny. Upon the second or third...

Bought new ring and pinion and install kit along with new axles w/ green bearings. My question is, in the package there was a solid spacer that came with the axles from yukon. It fits well between the two new axles after being installed in the housing. All seems well. Stock width. Is this...

I went with the 1350 big yoke on the 8.75 rear and now i guess i'll go with the 1350 on the spline coming out of the tranny. Any of you guys using these? What dia. of drive shaft are you using. I guess i'll go with the 3".

The slant is gone and the BB is in. I'll be hauling the car to the driveline shop for a build on a shaft. Is there any specific materials this driveshaft should be built from or just let em have at it. We'll be putting out somewhere in the realm of 550 horses in a 73 Duster. Big yoke. Frame...