Search results for query: *

farting around on Alibaba.com and I found this ad pic of a supercharged slant. Pic look familiar, Torqstorm? Odd that they (Dongguan Xiexu Hardware Products Limited) would use this RG platform to market their turbo systems......advertised 100-150HP over stock. Custom Oem Factory Centrifugal...

Turbocharged 273. Built a sheet metal intake for a TB and injectors. What size TB should I install for a 9-12 psi build? Hoping for maybe 380-400hp. I was thinking maybe 60mm-ish off something so I could get the IAC and TPS all in one piece. MS2 with 33 lb injectors. Street duty only.

turbo TBI project. Do I need a boost referenced fuel pressure regulator? Im planning on running stock 360 TBI on a 273 @ <9psi. Fuel pressure will be 14-20psi for TBI. Ill run a 48psi inline pump with a 14 psi regulator/return line to the TB. do I need to have the regulator increase the fuel...

I got an HX35w with some parts and I dont quite know what I got. It has a 'Banks Big Head' actuator, and a new Banks turbine housing along with a used HX35W compressor and center. I think the thing is a Banks 'quick turbo' package but I cant find any part numbers on the turbine housing that...

My CT26 turbo integral wastegate seat is burned so its leaking boost. Just looks like its eroded or burned. Do you think a 31mm copper exhaust seat cut for and pressed in would survive? Its where the flapper sits inside the hot side.

check this out...kinda crazy big block.

not forced but might as well be

If anyone needs a 1-2 bbl carb hat, I just saw a 91 Geo Tracker at the boneyard with a slick little OEM cast AL carb bonnet. Dont know whos blowing through a 1-2bbl.

just throwing this out for some flame fodder: Looking at a TIAL wastegate and I find they are upwards of $700 for the larger ones. If I was to make one out of...(insert Sanford and Son theme)...a large exhaust valve, a slant six water neck and a wastegate valve actuator? The whole setup is an...

Saw it at the OC auto show. Bright red, new headlamps, couldnt get closer than 5 feet ;-( intake looked massive.

Why cant a turbo face up? If you have the oil return facing down, whats the issue? My holset says +-10 degrees from horizontal mounting specs, just dont know why.

Im looking for 1 Holset HX30 turbine "split ring seal" or piston ring. Its the large one of 2 for the entire turbo, also 1 journal bearing. The rings are 35 for 2 and the bearings are as much! The whole rebuild kit is $35 shipped. Does anyone sell these seperately? Id imagine the ring as about...

Just ran across this pic, thought it was the ultimate turbo on the cheap...draw through! I dont get all the dynamics of a draw through, just the fact that you can bolt up a TQ is cool. Where is the blow off valve going to go, or the wastegate blowing raw fuel into the exhaust? Sounds......fun!

Check my two choices for a slant 6 blow through. Holset WH1C (HX35 with V bands) Toyota CT26 3.0 Supra turbo Holset is bigger with a 26 psi wastegate, CT26 is smaller but has a 9 psi wastegate, closer to what I want to run ( Im assuming that I can swap wastegates with a little...