Search results for query: *

Any one know how to reduce the pressure on a TRW power steering pump?

I'm not sure it is made or not but I'm looking for a frame rail repair cap for the back half of the frame rail. Left side for a 1970 Duster.

While I’m putting a fuel tank in the Dart I checked the rear shocks and they are shoot. I had KYB shocks on it but they are to long. Extended they are 23 1/2” long. I’m looking for 22” to 22 1/2”. Any help

Maybe someone here knows where I can find a couple of steering column parts for a 1973 P/S floor shift column. I need the foam gasket at the lower end where the column goes thru the firewall, and the rubber ring that seals the same plate to the column. Thanks

So if your looking at a A-body upper control arm, sitting on a table at a swap meet, how can you tell if it is a LBJ or SBJ control arm? Is there a measurement across the flats of the ball joint to look for? WHat is it? Or is there another way? Thanks

Tittle says it all. I have a 71-72 column but I don't know what it came out of, It is for an A body. How can I tell which column I have?

So my 68 Barracuda has SS springs on it. I can tell by the way the car sits higher on the passenger side and the fact that they are stacked different left to right. But I can't find a number on them? I'm not sure if I have 863/864 or 002/003 springs. Is there a way to tell? I want to change out...

I was able to buy the complete John Dillinger front suspension parts before he went MIA. Now I have to decide weather to go with a stock notched and boxed original K-member or a Qa-1 or what other K-member will work with Johns front end parts? I forgot to mention, this is for a race only 68...

Some one tell me the part number or where I can buy the bearing for a manual steering box. I need the bearing and race for the worm gear which is right behind the big screw in aluminum section directly behind where the column bolts on the box. Heck I'd even take a good used one if someone has one.

I'm helping a friend restore a 67 383 GTS dart. The car came with a partial new front end kit. I have two Moog ES 319R outer tie rod ends and need to order the two inner ones. We're using a 68 K-member. I noticed that 62-67 use Moog ES-319L and 68-76 uses ES-401L ? Can some one tell me what the...

Before i go and have a custom hose made. I thought i would see if someone has the fitting i need. I'm looking fro the fitting on the top of the P?S box on my Dart, I need one that screws in the top and has a female w/o ring for my P/S hose. The one i have is for a male flair P/S hose. i think...

Any one know of a supplier for manual steering box rebuild parts? Seals, gaskets,bearings, etc.

maybe someone can help me here, Will a 67 belvedere ps box fit a 70 Dart?

It's been many moons since I've had to replace the lower control arm bushings on a Mopar. What is the easiest or best way to R and R lower control arm bushings after you have them out of the car?

if anyone of the members here are on a budget or a student without much dough, i have all the front end parts i just took off my 69 dart that are still in serviceable condition. these are for the 73-76 disc brake setup. i'll send them to you for the price of postage. 4-balljoints inner-outer...

I just pulled the engine/ trans out of a 69 Dart I bought about a year ago from another member. Today i removed the comeplete front suspension. It has been changed to the later 73 up disc brake LBP allready. While I was under the car I noticed the calipers hit the sway bar when the wheel is...