Search results for query: *

Ok so I ordered a new fuel tank and a grommet for the fuel neck. Today I took the old stuff out today and I’m waiting on the new stuff. Is there any instal tips I need to remember? Like can you install the filler tube after the tank is mounted. I’m starting fresh with everything new. Including a...

3860S Carter 4 bl. What’s it off of?

So I have a 69 Dart 360 with a mild Hughes cam HEH2328AL which is 501/521 lift 223/228 @ .050 duration. I think I installed it at 104 or 106, I don't remember now. 2.02 J heads, LD-340 intake, 727 Frank Lupo 10.5 inch 3500 convertor. 3.21 rear. It has A/C, P/S, P/D brakes. So it is a cruiser...

Ok, so I have had it with having to rebuild the 600 Edelbrock carb from it sitting for a while. I have rebuilt it no less than 6 times over the years. I’m looking for a Fuel Injection set up that is easy to install and dependable. Car is a69 360 Dart with AC,PS, PB, 727. Has. A mild cam 2.02 J...

My 69 Dart gas tank was replaced sometime in the past. Before I bought it 16 years ago. Well here about 3 months ago I had to replace the sender/ pickup in it. While out I looked in the hole and the inside of the tank looks terrible. So I knew replacing it was in the near future. Today I filled...

Ok so I'm working on the fuel system install on my 68 Barracuda. I'm using a 12 gal RCI aluminum fuel cell (2121A),I'm plumbing this to a Fram HPG fuel filter, then to a 12-802-1 Holley electric fuel pump. From this point I need a little advice. Filter/pump is mounted on the inside of the right...

Having a extensive knowledge on hydraulics, (33 years a firefighter,19 years a driver engineer), how can placing a pressure regulator after the carburetor, limit the pressure a carb. sees? If you look at the diagrams on the Holley PDF, if you look at figure 3 how is this set up going to limit...

So I'm going to run a fuel cell in the trunk of my 68 Barracuda fastback. Mainly because I want to run3" exhaust all the way out the back and not running a stock tank makes it easier. So here is my question, I have a new Holley 12-802-1 electric fuel pump, and I have a Barry Grant BG-400 pump. I...

I was in my trunk and noticed that the small 1/4" vent tube that connects to the fill tube was laying open in the trunk. My question is does this metal line run thru the filler to trunk seal and just rides like that, or is it suppose to return inside the tank? Now I know why when I would fill...