Search results for query: *

Please put me I line for these.

Is this I take with the small bolts?

Looking for an early V8 904 transmission dust shield for a push button transmission. Don’t know if years matter or not.

That is the only thing I found there was nothing older than 1996. Oh wait there was a 1964 Rambler 4 door there

Was at the local Barry’s U-Pull it and found a classic Dodge Daytona just sitting there. And had to bring her home. She needs a complete restoration but I’m not letting her go.

Has a little bit of surface rust on it.

I’m doing a fresh up on my LA 318 just purchased the SPD 25 cam with new lifters and push rods. My question is I have a complete set of P4120249 springs that have been sitting in my garage for a while now. With this new cam and everything else being stock should I use these springs or stay...

Ok thanks good luck on the sale

Would this work on a 65 push button 904 tranny?

Thank you for the info. I’ll tKe them if they are still available

I need a small block for a 904 transmission plate how much to Biloxi 39532

Total to Biloxi MS 39532

Will these work on a 318?

Nice looking wagon

I know this is an old thread but if I remember correctly it kinda started to get support for some new rear glass seals. What ever became of that process? At the point where I’m needing the seals.

I got all the pistons out finally and one bleeder valve out and one to go. Thank you all for the help.

Thanks Jim, I picked them up a few years back and they have been sitting in the garage. I sealed them with brake fluid thinking it would help. I will give it a try one more time with the vice. I had one side start to move and I placed a clamp on it and started to pump and the other piston got...

Yes those are the brakes it’s been a long day. Thanks for the help.

Hello all, I’m in the process of changing over my brakes to the KH disc brakes. I have the completed setup but having a hard time getting the pistons out of the calipers. I tried air to no avail used grease got one piston out but can’t seem to get the other one out. I’ve tired to place a metal...

I didn’t notice the date of this post sorry, My plans are pulling the /6 for a V8 273 which I have a mini tube with spring relocation mod. That is for now. Would really like to find a 2 door sedan and make my wagon a two door wagon. Which would require moving the center post and a lot of metal...

Watching this as looking a doing a mini tub on my 62 Valiant Wagon

Can you get me the measurements so I can check to see if it will work? Thanks

Do you know if this will fit in a 62 Valiant looking at doing a 273 swap and need a radiator? Thanks

Anyone know how or what it would cost to ship the engine to Mississippi

Let’s hope from what I’ve seen it looks high up on the back of the block

I hope nothing major it appears to be coming out of the back of the block will be checking it out later today

Well went out to start the ole girl and she wasn’t happy for me not paying enough attention to her over the last couple of months.