Search results for query: *

i have a 69 318 that had a complete refresh basically a stock set up may have slightly larger pistons due to wear on the bore but a stock cam. The 69 service manual says that the timing should be set at 0 top dead center. The first test drive noticed while climbing a hill it pinged so what do...

on my 408 I'm running eddy aluminum heads eddy air gap and was running a 750 quick fuel carb. I'm getting ready for my winter project so I'm going to switch over to fuel injection TB system from Bill Hamilton fuel injection who i got hooked up with through this sight. I pulled the number one...

Hey all I have an issue that I wondering if any one else has run into this. I installed a set of eddy 60779 heads on my stroker 408 small block this winter and when I went to start it up it sounded like a sewing machine. It is a 1975 block it came out of a van I'm running a comp cam XE268H...

I have been in contact with edelbrock on the issue with the alternator bracket and they suggested to use an after market bracket that year one sells and when you look it up it mentions for use with aluminum water pump so, the gest of the problem is when you use this bracket you are sticking the...

Hey all I'm in the process of installing a set of eddy 6077 heads with a air gap intake on a 408 stroker motor and when I went to install my alternator i discovered that the heads stick out to far on the bottom so there is no clearance for the alternator to swing down into place. Has anyone ran...

I know that I have asked this before but, what I'm looking for is what is the proper way to install the gasket. Do you put a skim coat of a certian kind of sealer on or do you install it dry? Do you hurry and put it together right away after you put a skim coat of sealer on? or no sealer at all...

I have had this motor for ten years. It used to leak at the rear of the motor and I changed the gasket twice and still could not get it to stop leaking. Than this winter rebuilt motor to a stroker 408 and it started leaking in the rear again so I tried to go through and tighten all the bolts now...