Search results for query: *

Looking for a handful of the wire clips that hold the “rotor holder”? Onto the shaft. Little wire clip, with the ends turned up. We’re getting ready to put an advance limiting plate and change the advance springs in the distributor and would like to get some spare clips, cause I lose clips...

1965 Plymouth valiant guage cluster. Oil light works High beam indicator works Turn signal indicator works. The other 3 are guage lights Only the far right guage light works The other two do not. New bulbs, and we cleaned and tensioned the contacts on the sockets. Bad circuit board...

In re-wiring our project car, I noticed that the engine compartment, and under dash harness, were wrapped with what appeared to be regular electric tape. It was sticky and shiny. It was definitely factory. What is the definitive source or product used for a factory looK? Thank you. Eric

My son Jason ordered LED halo headlights for his project 63 valiant. My plan is to wire the HALO trigger wire into the parking light wire. That way when the parking lights are on, the HALOS are on. But when the headlights come on, the HALOS turn off. But here's my thought. Could we ALSO...

The above picture is what we are using for electronic ignition, and dual field alternator and regulator conversion . Two post ballast resistor, and four pin ECU. My question is, there are three unlabeled wires that go off towards the right-hand side of the schematic. One of them, obviously...

We're looking for some routing and sizing advice for our starting circuit wiring. Car is a 1963 valiant. Dashboard and all wiring harness came from a 1965. Small block engine. Here's my plan thus far. Battery cable from battery to starter. Feed 6-8 guage from large starter lug to...

It has 4 wires. Two pairs of two. IIRC a pink and yellow, and another harness with a blue and brown? Not finding anything in my wiring schematics or online. I'm assuming the wires are 1) back light 2) radio power 3) one speaker 4) the other speaker But I have no clue which is which. Any...

We are using a mopar electronic distributor and an MSD blaster 2 coil. Is a ballast resistor required for this combo? And under what circumstances can you remove the ballast resistor? Thanks. Eric

65K HEI IGNITION DISTRIBUTOR for CHRYSLER DODGE PLYMOUTH MOPAR 273 318 340 360 | eBay Other than the fact it's obviously made of chinesium, and that it looks like a GM distributor. Thoughts. It's for a stock 318 in a 1963 valiant with a 1965 firewall. Will it clear the firewall in an A...