Search results for query: *

I have a 360 Long Block for sale. Block is bored 0.030" over and is assembled with new rods, pistons, Lunati Voodoo cam (specs in photo) and J casting cylinder heads. No rocker assembly or pushrods. Engine has not been run since rebuild in 2010. I had trouble sizing pushrods without bending...

I have an A-727 transmission for sale. Trans was set up for use with a lock up converter. Valve body has a Trans-go TF-2 shift kit installed. Trans should be gone through due to some intermittent shift issues I had over the 2000 miles that I put on it. Good core for rebuild. No converter. Asking...

I have a set of 587 casting Small Block heads for sale. Asking $300 but open to offers. Heads are in need of cleanup and potential rebuild. Local pickup in Fontana, CA (92336) preferred or I can meet in the local area.

I have various small block accessories and gaskets for sale. Part numbers, descriptions and prices listed below. All prices are plus shipping from Fontana, CA (92336) Carter M60514 Small Block Fuel Pump (used for 100 miles) - $10 A1 Cardone Remanufactured Saginaw Style Power Steering Pump...

I have a 670 CFM Holley Street Avenger carb for sale. Holley part number 0-80607. Carb was used for about 1000 miles. I pulled it off for a rebuild and switched to fuel injection instead. Fuel rail is stuck in fitting on the rear float bowl and the rear float bowl has been removed once. I have...

I have an Edelbrock Performer RPM Air Gap intake for LA engines for sale. Edelbrock part number 7576. Intake was installed on an engine and run for less than 10 hours. Intake has been sitting in the box since 2011. Some remnants of RTV and water scale remain as shown in pictures. Asking $275 +...

I have a set of Mopar cast aluminum valve covers, black crinkle coat finish. Mopar part number P5007611 Covers were installed on an engine but never run. Been sitting in the box since 2010. Includes reusable gaskets and baffles. Asking $125 + shipping from Fontana, CA (92336).

Selling a Hughes Engines Aluminum LA Engine roller rocker kit (part number HUG 15023). 1.5:1 arm ratio. I purchased this kit about 8 years ago from Hughes and installed it on a 360 I built but could not get to fire. Ended up going with a Magnum headed crate engine soon after and have had these...