Search results for query: *

How fast in the 1/4 have you gone with 1 5/8 headers with 3" collectors? ET, mph and car weight? Thanks.

For a 360 stroked to 408 that is a RACE only engine with no oil mods done using a solid flat tappet camshaft, 8 qt pan and RPMs stay under 6500 rpm which style oil pump do you guys like to use? Standard or High Volume?

My dad has the Trick Flow 190 heads that have the following valve springs. He went with this option so he could get the 10 degree retainers. 1.550” O.D. Dual Spring (TFS-16094-16) 138 lbs. @ 1.950” Installed Height 430 lbs. @ 1.250” Open 420 lbs./inch Rate .680” Maximum Valve Lift He is...

Looking at Howard cams and their lifters and some have the ending DL, Apparently it means a Direct Lube lifter. Engine is a 360 LA and will have a Mechanical flat tappet cam. Are the direct lube lifters worth the extra $ and does anything special have to be done to use them over the normal...

My dad is freshening up his 408 after the block cracked a cylinder. Curious if a cam swap would help or not. Car is 3250ish with driver, 408, 727, 5000 stall convertor, Dana 60 4.56 gears, 30" Tire. Shifts the engine at 6000 cross 1/4 mile stripe around 6400. Car has been low 10.80s. The...

Looking to upgrade to a MSD 8534 distributor. I already have MSD 8 mm wires on my car, but they have the stock Female ends. Does a stock cap work on a MSD distributor or can you buy a cap to accept the female ends?

Are the earlier/older 360 blocks better than the newer ones? I've heard that some of the 1st 360s were built using 340 cores thus resulting in thicker cylinder walls. Have and engine now that I'm certain has cracked on the backside of cylinder #8 and think the block is a early 80s but have to...

For those that run Cometic Head Gaskets on your aluminum headed engines are you using C5917 or C5622 part number gaskets?

Need a pickup plate/coil for a small block distributor. Electronic Ignition. What company makes a good replacement?

Current engine combo: 360 .030 over Scat 4" crank 11.3:1 Stock OOTB Edelbrock Perform RPM Heads Victor 340 intake 1.6 rockers Lunati Soild flat tappet cam: .550/.571 lift 256/268 duration @50 Lobe Sep 106. Current combo ran 7.0s in the 1/8th in a 3250lb duster shifting at 6,000. If I were to...

Can anyone tell me who the maker of these rockers might be? Best picture I have, found them for sale, and seller doesn't know who the manufacturer is. I'm thinking Proform, but not sure?

Looking to upgrade my rocker arms and shaft from the stock 273 ones. Is a race only engine but only sees 6000 rpm and has under a 600 lift cam. Been looking at the Mancini Rocker arms and they have them on sale right now for $450. Anyone ever have any issues with these? Is there another...