Separate names with a comma.
Hello. Does the not- needed points distributor have the bottom mounting plate?
I'd like to buy that piece.
I have a couple unidentified pans #087 & #987.
Hi Kim. 54” center of the joints or longer. I’m prepared to have it shortened if so. I have a lead on the shaft locally. But no slip yoke....
Hello. Collecting the parts to 833OD my D100 NP435. The yoke or the entire drive shaft if 54" or longer.
Mine's been cut .100, chambers are 45cc. This is a later drool tube head #2843169.
Hi TD I have a 2nd engine I'm assembling on a stand to eventually swap in. Would be nice to have it run up, broken in and checked for leaks...
Hi TD Appreciate the offer. More than I can spend. Thank You.
seat belts from a 2015 Dodge
Hello. For reference, whats the distance between the 2 wider bolt holes?
Yep. Finding it cracked was a complete surprise. I had a coupe of days to get the clutch changed and had to braze it up quick. Still holding up...
Great work! My bell was cracked in the exact same spot. What did you do about yours?
Thanks for the pics. I wish that piece of tin was the answer!
These have the sump all the way at the back by the flywheel and the dip stick tube coming out of the driver side. Does not need to...
PM the fuel gauge
This is what I am hoping was factory on the '70's trucks. obviously an older series but helps illustrate the notion.
Morning Hyper. I figured Chrysler had designed a similar bracket for this config. It's a slightly different situation because the flywheel is...
Hello All. I have a '72 D100 with a slant and NP435 granny trans. I've been searching for pics of the triangular bracket that supports the...
Slant 6 hardware. Message sent
I have the same issue with my '72. There's a rather heavy gauge brace that's fitted between the driver side of the block and the unsupported 1/4...
Hello. How do you pack these for shipping? I'm in 90025
Hello. Like to purchase... 8 3/4, 7260, 10 spline yoke. Payment thru Paypal?