Separate names with a comma.
Try Daytona carbs in Daytona Fla.
OTC wrist pin press, the piston never has any pressure put on it.[ATTACH]
There is a special tool to hold the rod when pressing, If your shop doesn't have one move on.
I bet if you put one end of the T-bar in the crossmember with out a LCA in, you could move the T-bar up and down a good 2"
HaHaHa I under stand what you are saying but it's not that drastic of a angle.
If your that smart, figure out what the angle is in 3/4" at 35" long
I would go for it, You are talking about 3/4" drop in 35" of torsion bar. It wont make a big difference.
Thanks everyone for the responses
Nice, never seen this site before
I can't remember what year but they had break off jerk fittings.
They would grease them than break off the fitting.
Does anyone Know the length of a 69 Dart from bumper to bumper.
I need to see if I can get one in my garage before It gets here and If I need to...
Get out the magnifier!
I would try a big truck repair there is one in Akron Ohio that I would call and I'm sure they would be way cheaper than a classic car repair...
not much for small block, or should I say none
looks like there pre-rusted lol
got a picture of what you needPress on bolt on solid or slotted
I forgot about the 11" clutch being a Abody guy.[ATTACH]
I thought the bearings were all the same for the A833
I would take them apart, take the back off. Wrap each in cardboard then tape the two together then wrap them in cardboard. I get bicycle boxes for...
I will take it
I would use a shim of stainless. It has always worked for me and never fails.
You know you can't use a steel shim gasket with aluminum intake, It will always leak.
At some point sooner than later you will have a major mess...
Looks like 2 different spindles, if you look at the one it has a bigger inner bearing than the other.
Hemi Orange if I remember right, at least that's what I use.
Here is the VFD paperwork that came with my unit that is a AT1, if you look they make a AT2 that is single phase to single phase.[ATTACH][ATTACH]
Mains still need line bored?
What is the casting date on the block .
I just put a phenolic 1/2" spacer on my buddy's 67 dart 383 and I was surprised that the carb was cold after a good drive and it ran a lot better,...