Separate names with a comma.
I believe it. He has some defect going on.
The front pump is pushing outward all the time, so I believe auto trans to be harder on the thrust.
Thrust bearing is wasted.
Pull the motor
What I'd give to have that body style. I was close 2002, should have. Cant find them now. I hear you on the stuff your friend told you there's a...
Flat head, rubber mallet.
Knock it out the back. I use a 2x4 block and light rtv when knocking in the new one
Lol well putting it down some doesnt hurt shit.
Sinking it does. Yes.
Post one of this thread shows what sinking it looks like, it sucks. Putting...
one thing that will raise the oil pressure is when you close something that bleeds off at the end of the line like rocker shafts upside down..like...
People might say the same about you .lol
Just kidding ya. That's fine. To each his own. Everything is specific, you can get carried away ,open too...
Would you take 150 for the carb?
Delenzie converters is where I bought my last "cut high stall" lol 200 bucks with core
2600 or so stall
Sounds like a good explanation.
Many guys still bend and braze with the factory case.
The angles are good, but removing too much material at the chamber around the exhaust, for me at least showed no gain and a small loss. I've put a...
That's what I did. I had them cut the spring seat of a 69 slant head till it hit water.
We wanted to find .050 more installed height... 1996, we...
Stock/factory cases are smooth.
Somethings off.I've put them back on with the old gaskets and they never leak.Take and rub the flat of it on a flat table with some 80-100...
Theres 2 or 3 types.
1.holes all in the row -tendency to twist and break when torqued/re torqued.
2. Holes staggard up and down -strongest version...
Like a slant?That's about .080-120 thick.
Some heads, like truck 318 heads, without longer valves or ...... you cant get a real spring in there....
You mean bugging the ever living shit out of the poor builder who ends up taking on your job?
"Back into the port and not the intake"Hmmm.The exhaust, simple..like water coming down a fall over rocks. Too much removed around the...
Not much out there for 1.624 lol
Pop up Locks or cut the spring seats down.
No way would I put it together like that. That's bad.
You need at least .050 between coils.
Yep. I'll ad that he better drain/flush it before trying it if he does.
Its hammered time...HBD!
SHS could be the company or the designation of "street high stall"
The case is unique.
It's not the typical stock convertor case that's inerds are...
One keeper is hokie, it gives for higher readings than the actual height with both. I'm sure you can slip by, but I dont recommend it.
Maybe $800-$1000 "as is" being numbers are unknown.I see a " DRE"
I'm guessing D.... Racing Engines
If you can figure that out...they will...
Build it yourself.What happened to all the killer mopar shops rumble and moper used to brag about?
He blew one up. While back.
On the exhaust it effects flow. They say the ledge helps. I've never heard that on the intake side though. I'm open to learning if you can share...