Separate names with a comma.
Perhaps check your torque specs.
741 small pinion doesn't have a crush sleeve .Chrysler Differential Info
I've often gained clearance at the torsion bar by careful using a ratchet strap around the trans, or t-bar as nec., to coax the tubes/collector...
So there IS interference .
Thank-you Dave .
Do you have the crank bolts in place, Dave ?
Next time you get one - post a pic !
I'd really love to see it ! !I knew I had you on "ignore" for good reason !
It's not uncommon for an engine that was sucking/burning lotsa oil, to accumulate a " tar " in the exhaust system that can take quite a while to...
The disc won't go in backwards, the flywheel bolt heads will interfere .Borg and Beck or Diaphragm design pressure plate ?
If B&Beck, install...
Did you have the flywheel resurfaced ?
If not,. That'd be my first move.
Should come with the new M/C .
If not, a small piece (as picture) of vacuum, rad overflow hose or similar will work. .
M/C pushrod removal .MC Pushrod RemovalCheers
Your current brake lines will screw directly into the new M/C, no fittings nec.
Pushrod will be correct .
The residual valve can be removed by...
MC36406 is favored for it's 15/16 bore, and as mentioned, direct bolt on.
Will work with both drum and disc.
As mentioned, residual valve behind...
Not near enuff ! !
Hope he doesn't come back, you will end up with another regret ..
Been there .
Be very careful not to bend that cover plate.
They can be very difficult to get straight, and NOT make a different interference noise.
Nope, don't know it, but there are many more islander members closer to that area, they may have some input.
Got a link to the car ?
Yellow, or primer ?
Running noisy, - touch/feel the dust cover on front of trans.
Interference should be felt there .
Choke . - fast idle setting
Also mentioned in the instructions. lol
Good job !
Reading the instructions helps !
Had another fella a yr. or so ago, also tried to install the drivers side from the top, rofl, pounded the tube...
I think your cluster gear, bearings, an/or counter shaft needs attn .
A general overhaul would be in order.
Yes, should be fine to drive, as 4th...
Sounds like more work than long tubes, with none of the advantages .How much for the special headpipes ?
Good tuner can make it idle any way you want.
Might not run wortha chit ! !So funny, we used to make these changes in search of speed/power.
They are both of the modern design .
After warm-up, running bad, - I'd undo each rocker shaft bolt one turn, and see if it ran any better.
If it did, I'd tighten one side, then the...
My 69 340 4spd car has had them front and back since new .
MOVING WHEELWELLS 101
Try 67 Nova.
EvansWiring.com : Product Catalog
That was a few years ago, close to xmas, as I remember it.
Great quality .