Separate names with a comma.
your inbox if full
do you know if it has the stock jets and rods in it?
i use a light coat of black rtv around the lifter galleries, just to have that piece of mind. Also Chase the threads with some lube make sure they...
i got a 1990 318 with 302 heads milled and ported 9:5 CR roller cam regrind 260/264 in my 67 Barracuda that thing hauls serious ass. Easily smoked...
manual choke would be better, im looking for a running carb how much are you asking for the 69 carb and 70
looking for a 68 340 carb avs style or anything 650cfm carter edelbrock. shipped 91770
Yup, I read the article too, sounds like bullshit I grew up right next to the 10 freeway I have no problems with breathing. I heard they can not...
If you can remove that truck bed that would help you out a bit, but damn that’s pretty snappy
That’s not bad.
If you want very mild then, put a performer intake 600 cfm and swap the camshaft for something in the 258-260 duration range. Get a 73 340 driver...
Got one off my 65
looking for a ready to run 67-69 273 radiator or 318 aslong as the radiator. Shipped to 91770 or local around the area thanks!
Hell yes!!!! You are completely right, they have to start from the mind set of not knowing and first time install.
Yeah, but man those instructions sucked. They need to update it with a longer sway bar bushing bolt, and stamp on the bar this side up. Etc.
Yeah, I just mocked up the sway bar, then used some yellow paint with a q-tip to mark the spots to drill on the frame. When did you order the sway...
If you see the manual picture the center of the sway bar is down then raises up, I had tried it both ways, it was impossible to have the sway bar...
Hell yeah, I been driving taking turns all easy, biggest difference!
That's the way it was in the manual and I tried it both ways flipping it over was impossible to get the sway bar bushings to connect.[ATTACH]
Cool, just remember have the brackets on the k frame hand tight, then the middle clamps not even connected, then connected the sway bar bushings...
so, since I like to go fast and make turns I installed a front sway bar on my 1964 Dodge Dart. I used the kit from hellwig. On my 1964 dart I did...
Thats crazy my 500cfm eddy was lean out the box, actually had to jet up to .89 with with stock
rods secondaries where 1 stage leaner, i have the...
came out of a 727 small block trans with the number and letters shs 10423Any idea?
That's the same tire combo I run, nice fit for an early abody
Yes, but you will need a porportioning valve to decrease rear braking power. Nothing hard! Good luck!
I actually believe 275 60 15 looks better on a 7 inch rim fits better too
slant six gas pedal $35.00 Shipped USA
Brake pedal assembly $99.99 Shipped[ATTACH][ATTACH][ATTACH]
The picture shows 2 piece one is bent a bit, but i actually have 3 in total the third one is in good shape. 135.00 all three Shipped USA ONLY...
hmm dont matter as long as its a 68 intake, im actually going to slap it on my 273