Search results for query: *

I have a 73 dart swinger with a 318 and got some new long tube headers. The one on the passenger side only has clearance issues with the torsion bar but the drivers side is a bear... I can't install the steering box from under or over and the lower bolt won't even go in. Based on my research, I...

Need 1 5/4 small bolt pattern front hub assy. Bearing included if possible. 10" drum. Please and thank you.

Hello all, I am working on my 74 dodge dart and unfortunately my front hubs and drum covers did not survive due to rust. I having a hard time finding what would be good to replace these. The wheels are 14 inch and it is a 5 stud pattern. Does anyone have any suggestions?

Hello all, I'm so close to bringing my Dart to life. I have crank and fuel but no spark. I bought a spark plug test light and verified. I looked for voltage to the coil with key on and it is getting a bit over 6 volts on the positive and 1.5 volts on the neg. I checked the connector going to the...

I had an initial thread that helped me through a blowing fuse issue and that is all resolved now. Thank you so much. Now I'm trying to solve an issue where there is no crank from the ignition switch to the starter. I checked for voltage with the key in crank to the ignition yellow wire on the...

I am totally green around the ears and strictly trying to wire my 74 Dart with the Painless harness manual and OEM wiring diagrams. I believe that I have done everything to the book. I am jumpy about posting stuff due to trying to not look like an idiot... but here goes. I have wired the entire...

I noticed that I need an idle position solenoid on my 318 small block. I have a factory 2 barrel carb. I can't seem to find a listed replacement. I have a 74 Dart. Are some solenoids universal or am I missing something?

I have been working in a painless harness 90542 21 circuit. I'm a little confused on how to integrate the ignition module, and TPS sensor. The new harness has been really good about matching wire colors but there is no mention of either unit. Do I integrate both into the harness via the OE...

Hello all, I was hoping that someone could assist me on what a specific wires function is on a signal switch. I'm familiar with all of them but the pinkish one at the bottom middle right. I've looked at OE manual and can see a pink or 2nd red wire coming from the switch. Any help would be...