Search results for query: *

Saturday steaks barbecued

Well, thank you for your help. It turned out my eyes were larger than what the car could handle had to change to a 215/60r14

America’s tire is helping me by putting on three different sizes of tires so I can figure out what will fit on the barracuda. Tire sizes are 225/60r14,225/70r14 and 236/60 r14.

65 dart charger the money is on it’s way for center grill part

This heater box should work for 1966 barracuda’s?

Here is one of four others

Well it’s been a long time thought I’d give you an update I pick up the rims tomorrow photos soon

Thank you for the photo but I will pass.

Thanks for posting the photos for me. I see that the wires are cut, can you tell me if the sockets can be removed?

Hemi71 GTX, Jim I’ve used Porterfield out of Southern California. Give them a call and see if they can help you out. They supplied me with the Kelsey Hayes break pads

Saturday barbecued St. Louis ribs

The angle I took the photo it appears that it hits, but it doesn’t

Well, the wheel sure does look great. Where did you find your center caps? Do you have a part number for them? What car do you have have them on?

The rims have been drilled for a larger out diameter lug nut for a 7/16-20 thread. One rim was not drilled. So new lug nuts with conical washers. Can you post any photos of your rims on a ride? Thanks

After owning this used set of American torque thrust T 70 r for a couple of years. I finally found a person out of San Jose, California to restore them to go onto 66 Plymouth barracuda. Over the years, I have only seen one other set. I purchased them around June 2020

Saturday night pork chops

5 minutes later After another 6 minutes Here’s how it looked plated

Sunday night ribeyes cooked on a 26 inch weber Glenn blue

Hey superbee6 your inbox is full.

Getting ready to replace the power steering box since I have a massive leak so I’m getting my core stripped and down to send back

Here is what the ribs turned like

BBQ on my 26 inch Glenn blue special edition Weber

Second in line

I painted my engine bay on my 66 barracuda with a rattle cans from Napa auto parts. If think 4 cans have 5 or 6 made up. When you think our done walk a way then walk away and leave it set up then haul off all the tape after a good time

PM sent

The sweepers on my weber barbecue had failed so I put a new sweeper kit in today

It started as a 318 but stroked to 390

This is a the photo from my 1968 dodge dart that I sold.

Jim, Here is the check valve I was talking about in the conversation.