Search results for query: *

The dragstrip needs some work.. it's been going down hill for a while now. They won't sink any money into it. Just another by-product of our Country's recession.

I do have a few recordings of some footbrake finals at my local track.. but they were recorded on my cell phone so the quality isn't the greatest. I'll upload a vid of the truck to youtube and post a URL so you can check it out! It is a cool little truck. I've driven a lot of vehicles down the...

haha!! Thanks. The engine bay isn't too much at the moment but the truck was certainly "rough' when I bought it. I've done well with it though. I've won 10 or so races last year and won the points championship at my local track in Footbrake. I got a good deal on the truck but it's starting to...

I'll take a few shots this weekend. Until then, check it outt!! :)

I'll take some pictures this weekend. I really don't have too many at the moment.

Thanks for your response!! :) I think we all have a tendency to devalue our own time especially when it's our own "stuff" we're working on. Plus, I enjoy the work and taking ideas in my head and implementing them into a product. That's why I became an M.E. However, applying logic to the...

The fit isn't too bad at all but certainly could be optimized for greater efficiency. The length of the primary tubes are all close.. but the 90's aren't elbows,they are two separate pieces of pipe cut at a 45 degree angle and welded. The diameter of the pipe isn't consistent. Looks to be 2"...

Thanks for your reply and compliment Bob! I'll post some pictures of the truck whenever time permits. I've been quite a busy fellow here recently. I've taken a look into the Hooker Fenderwell Headers already. Those headers look extremely aggressive under the hood and I'm a fan. I have a...

I may end up having a set fabricated specifically for the truck. That would be a last resort though. Similar to the laws of nature, I want to take the path of least resistance. However, $800 dollars doesn't seem too terrible beings that any decent "shelf" header will be in the $500 range. I'll...

I have an '84 Dodge D50 w/ an iron headed 440.. runs 6.60s in the eighth. The truck has started to receive a lot of attention since I've owned it. I've started investing some money into with a nice fuel system, new suspension (ladder bars, coil overs, frame rails, etc) and the next area of...

So I have a 72 Duster that I race only bracket race in an 1/8th mile. I've never encountered a tranny problem until..... Last winter, I re-did my engine. Car previously had went a best of 7.05 and a worst of 7.33. Had my heads worked from 260 cfm at .600 to 294 at .600 and intake was port...