Search results for query: *

All 741 pinion are suppose be 1 3/8 with a 29 spline Pinion according to every parts manufacturer I've found. That's why I can't figure this one out.

So ,I finely got around to disassemble my 741 housing. The new ring and Pinion has 29 spline pinion, as all the parts catalogs show. But mine has a 10 spline pinion . I measured the Pinion thickness, both old and new are 1 3/8 thick anyone ever run across this before?

I don't know what the difference between the a,b,c and e body backing plates. I haven't made it over to where I store the differential. Maybe tomorrow I can get over there tomorrow to take pictures. I could probably repair them, but I would by new ones if they weren't too pricey.

It's out of 1971 Demon that sat in field for 30+years. It's a small bolt pattern. The brake drums are shot. There badly rusted. It has 4:10 gear, that's rust pitted. It think I may have bent the drums when trying to get them off. I did find rear drums at Layson restoration.

So I finally broke down and bought a 8 3/4 small bolt pattern differential. Unfortunately the brake backing plates are damaged. Any know if they are reproduced? I can find all the other brake parts in need.

So I got the car back together. Run good and is quite.

I all ready have the intake and timing cover off. I will be removing the valve covers next. I will be cleaning and flushing the engine. I will drain the oil, replace the filter, run it and change it again.

I drove it less than 3 miles,never lost oil pressure. Let cool for about a hour and moved it into the car port,no noises, so I think I'll be ok.

More respect!

4 Update! It was the timing cover!

Is that the water pump side or the engine side ?

Thank you gentlemen. I believe, when this car was in California, some was running it with water in the cooling system. It's has had all the freeze plugs replaced before I got the car. To put that much coolant in the oil in less that a 1/2 hour and it ran good,I can believe I have a head gasket...

It has 176,000 miles on it. I'm the second owner and have all the maintenance records. I did notice a few drops of coolant by the cover late last year. I'm going to pull the cover off tomorrow. Thanks !

Yes,it had 50/50 mixture of coolant and was stored in a heated garage.

So, I just got my Demon out of storage. On the 2 mile ride home, it overheated. It put a gallon of coolant into the engine oil. It also had coolant in the air cleaner. I pulled the plugs, no coolant on them. It also ran good,no missing, or running rough. I pressure tested the cooling system. I...

So, had any one have luck get the correct spider gears a 7.25 ? The two sets I ordered see to be incorrect.

I want to replace my spider gear set also. So far I haven't had luck finding the correct gears. Chrysler had two versions of 7 1/4. A early version with a 9 bolt cover. Late is 10 bolt cover. Yours and mine are 9 bolt. The two set I ordered where incorrect.

So after more research, l found all 8 1/ 4 differentials up to 1972 take the smaller seal and bearing. $60.00 in parts, the noise is gone. Can't swap too a bigger differential that cheap. Found one pit in the outer race on the right side.

When I had problems with my 72 demon, non rally dash, it was the regulator on the dash. Mine read to hot. I would get a factory service manual. You could also have a wiring problem at the bulk head.

Ok here's my question. I have 7 1/4 differential in a 1972 demon. 318 v8 with 10 inch drum brakes. In need bearings and seals . I am dealing with a older parts guy who knows his ****. Some catalogs show different bearings and seals for 9 and 10 inch brakes, others show the same numbers for...

I agree one hundred present with you Dan. After 20 years in car dealers ,it almost killed my love of cars.Thank god I got out of it!

that would be a quick sell on the south/east side of Chicago!

yes,i have both of the above kits,also john ambulance,a chevy van made to look like a Chicago police.

the plush horse ?

I need to make it out there this year.Car is in the body shop getting r/s door fixed after some one backed into it at first car show this year that I took to!

haven't been there in few years

Chicagoland area only. 1996 and newer only.

I'm across the Cal-Sag from Karl ! palos Hills

I put my 10 year old to bed at 9 so I can go to bed!!!