Search results for query: *

This intake/carb were on my 500 MW pump gas motor when I bought it from the engine builder. It was used for the break-in runs and 6 passes at the track. I replaced this intake with the Indy 440-25 so I could run in the NSS races. I ran 10.85 off the trailer in my 65 Coronet with no tuning. So...

New still in package. Part # 9.8118 Fits 62-72 Dart Demon Duster Valiant and up to 69 Barracuda These came in a kit for my car but I don't have a sway bar. They sell for $16 in Jeg's then $10 for shipping = $26 I will take $17 shipped I have PayPal or Money Order will do also.

I just swapped this out of my 65' Coronet for a Dana 60. It has road grim on it but easily cleaned off. It will need a new vent tube because like a dumbie I broke the darn thing removing the brake T-block. The rear has the stock perches and in board perches on it. If someone is interested...

Bolt onto a RB and be NSS legal. Edelbrock CH-28 intake that has been Jet-Hot coated 2 Carter AFB Comp Series 625cfm(electric choke) Edelbrock Progessive linkage and Fuel line 2 Chrome Air Cleaners ARP stainless intake bolts and carb studs Chrome spring return brackets w/springs...

Like new, they have only 6 passes on them. I need a taller/wider slick. $325 shipped. I have PayPal

An almost new set of Stockton Wheel steelies. 15x8 w/4.5 backspacing, 5x4 1/2 bolt pattern. They come with the locking valve stems. They have six 1/4 mile passes on them. Going to a wider tire so need a 10-12" rim. $250 shipped. They were $365 new so a good deal for someone. I have PayPal.

They have 6 runs on them. All burnouts were very light. Going to a 10.5W/taller tire. $325 shipped. I have PayPal.