Search results for query: *

Thanks

I have a 70 duster, planning to upgrade to big bolt. I just picked up four 15x7 cop wheels. Will the 15x7 work on the front? If so what tire size for front and back? If anyone is running these on a duster could you post pics. Thanks

I'm looking for a driver side trunk gutter for 1970 duster

741 is what i have, i was hoping someone had a good used set.

Im looking for 3.73 gears for 741 case

Ok would this cause my problem, or something else?

No, directions just said remove and discard.

Directions called for leaving out three springs #1 1-2 accumulator spring (big spring on top of valve body), #2 spring and check ball in valve body, #3 shuttle valve spring (i installed a plug in the shuttle valve). Also it called for installing a steel ball in spring for 1-2 shift control valve.

i didn't adjust the rear band, directions say just the front one. The problem seemed to be in all gears, although i didn't want to drive much. I will try backing the band off some. If that don't do it i will pull valve body and recheck all the steps. Thanks for all the help.

it is set at 72 inch pounds and backed off two turns, problem is in drive or manual shift, the kit is for this year. thanks any other ideas.

yes, i did back it off two turns. I think it is called shift overlap. Hope someone can tell me what in the valve body controls the timing.

i just installed a B&M shift improver kit in my 72 dart 318 with 904. Before install it was shifting fine but not hard enough. After install it shifts fine at half throttle or less if i am above half throttle it has a putting on the brakes sensation. I have rechecked torque on kickdown band...