Search results for query: *

I'm currently swapping out my timing cover and as usual i tend to over think the process. Can anyone tell me if there is a specific tightening procedure to ensure the front seal is centered to the dampener hub.

Just in the process of swapping out my intake with a LD4B on my 66-273. I decided to do some preventive maintenance and check the rocker arm adjustment. The engine has and Melling 23203 hydraulic cam (specs below) with Melling MPR-155 push rods and adjustable rockers. To my surprise there was...

Looking for a good LD4B intake for my 273 that doesn't require a bunch of repairs before its installed...

Hi all, I currently have a 2176 Edelbrock Performer intake on my 66 273. I'm currently searching for a good LD4B intake. Before I waste a bunch of time can anyone tell me if there's enough hood clearance on a 66 Barracuda for a LD4B intake Or would any of you know the deck height of the intake?

I purchased a turn signal cancellation switch and thought the horn ring would simply come off by pushing down in the center and turning one way or the other but had no luck. So I thought before I break something I would ask the question. HOW DO I REMOVE THE HORN RING?

I have a 8 3/4 with a 489 diff. I noticed a wheel bearing noise from the rear so i pull both shafts, the right side was bad. However there was no way to adjust the axle end play. My question is do all 8 3/4's have adjustable axle shaft flanges/nuts?

I'm in the process of refinishing the grill on my 66 Barracuda and am looking for a god web site or some accurate information on the paint code for the front emblem as well as the correct colour for the inner part of the grill.. Any help would be greatly appreciated...Thanks Joe

Has anyone used a hyd 23203 Mellings camshaft in a 66 273 block?

Has anyone used a hyd 23203 Mellings camshaft in a 66 273 block?

I purchased a 66 273 Barracuda, the engine was rebuilt before I purchased it and the car runs great..It came with the orginal 4121s AFB carb and I can't find the CFM rating for it but I assume its in the low to mid 400's. The engine's dyno sheet shows 352hp @ 6000 rpm and was dynoed with a 660...