Search results for query: *

I'm planning on doing this swap over the winter months to my 73 Duster w/ an 8.25" (now if I could only find a hoist that would fit in my igloo). I'm sure somewhere there's an answer to my question in FABO but to make it easier, which years & models of the Grand Cherokees & Dakotas have the...

RockAuto shows senders for a '69 Dodge Dart 340 in 5/16" ... 3/8" ... 1/2" in the $70 range.

It looks like you may have to buy individual pieces from Rock Auto to get the 10x1-3/4" stuff you need.

Here's a link to the RockAuto site which may have what you need ... https://www.rockauto.com/en/catalog/plymouth,1968,barracuda,5.6l+340cid+v8,1228621,brake+&+wheel+hub

Everything I see shows 2.25" width for a 10" front drum setup ...

Possibly detonation ... timing advanced too much or carbon build-up??

340 or 360??

RockAuto has them for $2.13 CAD (part #USA33067) but there's a lot of other differentials out there uses the same, including: Chrysler 8.25" and 9.25", Ford 7.5" and 8.8", GM 12 bolt, 8.5", 8.25"

Praying for a fast recovery for your back!!

I actually decided to stick w/ my 8-1/4 for now so unfortunately I can’t help out ... sorry.

Winter's here ... throw in a block heater.

Not sure about that specific number but RockAuto has application specific ... may end up being the exact number you need (rebuild part numbers are different though).

Thx!!

Link is not working for me ...

I've had good luck w/ PowerStop from RockAuto ... that brand is also available through Amazon.ca

https://www.summitracing.com/int/parts/mil-81320/overview/make/dodge

Good to know ... Thank you!!

Wow ... now that's detailed!! I will see what I can do ... no promises though.

That would be where your EGR valve sits ... previous owner probably felt it was a good idea to get rid of all pollution garb.

Yep ... one was missing on the 3-4 synchronizer assembly ... thankfully everything else looks good!!

I will definitely take a look ... hard to say who's had their paws in it or what's been done to it.

Awesome ... thanks folks. At least now I know what's broke ... gonna take a close look at everything else while it's apart.

I was getting ready to install my A833OD back into my Duster & decided to replace the pilot gasket/seal & side cover gasket. When I got the cover off I found this critter on the bottom. Just wondering if anyone has any idea which component it's from. I plan on disassembling it all but not...

Thanks ... perfect!!

Awesome thank you SO much!!

This may already be covered in another thread but ... does anyone have close-up photos of an a833od shifter / rods / linkages etc for a 75+ A or F body ... installed. It's been 12 yrs since I took mine apart & never had a digital camera back then to show exact positioning. TIA

Looks like maybe this was rectified in another post ...

The only shield I know of is the dust shield like this one:

Looking for A/N items to fit factory Hurst shifter ... I have the tabs but not the rods. TIA Jim