Search results for query: *

Can someone please provide a picture of where the rear outer seat belt anchors belong on a 67 Dart GT. I am working with a car that was previously tubbed and am restoring it to mini-tub. Can't identify where the outer seat belt anchors should be.

1967 Dart GT trunk finish panel or moulding set

I need both sides roof to outer wheelhouse braces for a 1967 Dart GT. The previous owner hacked the braces out to install tubs. I am removing the tubs and restoring to the OEM configuration. I have attached an image of what the braces should look like, and an image of what's left of them in my...

I am told the OEM strap P4120468 is lo longer available. Can any one tell me if the NEAPCO 1-0023 strap is a reliable substitute component for a 450 HP "street car" with 10 inch tires? If there is a better option, please advise. I have looked at the Moroso girdles, but I dont want to drill...

Need the two floor anchors for the rear seat, 67 Dart GT.

I have a pair of buckets for my 67 Dart GT but the seat tracks and stand-offs are very rusted. What other vehicles can I get these from?

Rear seat for a 1967 Dart GT. Decent front seat to floor stand-offs (tracks).

I have a foam gasket and a steel gasket. Which one goes where? Also, if everything was correct, what is the maximun axle end play I could possible get? I have none.

How much is the desired driveshaft end play on a 440, 727, 8.75 (4.10 gears) set up with SS springs? I am only measuring 0.450 inches and only want to have the driveshaft shortened once.

I've got the 8 3/4 rear sitting in the perches with about 3 degrees down on the trans end of the driveshaft and about 4 degrees up on the diff end of the driveshaft giving me the one degree difference I think I'm looking for. How much spring windup should I expect and adjust for on a "mostly'...

After the back brace was installed on the 8 3/4 housing the rear shocks wont clear the housing. Is there an easy fix for this? 67 Dart GT

Will welding a back brace to an 8.75 housing change the toe? I ask this because I just had one welded on and while setting it up to drill for U-bolts found that both axle flanges are toe out.

I am looking for GOOD quality 8.75 axle perches for SS springs with the 1/2 inch locator pin. I see Moroso has them... not sure about the quality. Anybody have any recommendations?

The previous owner hacked the rear seat/trunk cross bracing out of the vehicle I recently purchased. I have been unable to locate replacement sheet metal to restore the bracing to what it should be. Does anyone out there have donor parts for sale or can tell me where I can purchase these...

I just purchased a 67 Dart GT (gutted ex drag car). I am trying to build it back up to a 440/727. I purchased a BB K-member at a swap meet and the correct BB motor mounts. With the drivetrain installed, the trans pan is not level. It sits about 1/2 inch higher at the rear flange than the...

What has to be done to replace the rare and expensive 1967 winshield w-strip and molding with the 1968 version? Got pictures of clip placements?

Wanted: 1967 Dart GT center grille emblem.