Search results for query: *

price is being reduced to $5500 obo. Transmission shop says front clutch is bad

Price reduced to $6000

Price is being reduced to help sale $6500 obo

Yes sir it does. Hose measures 6.5ft

this is a pro comp fluid filled mechanical gauge without the light. Comes with auto meter steel braided line if you choose to use it. Also the fitting for using a regular rubber line for the engine compartment. There is some dents on the bezel pictured. These go for over $150 combined. Looking...

Came out of my 72 duster. Find could use straightening but it's in good shape besides that. $50 obo plus shipping from 28562

72 Plymouth Duster Engine is a 1997 360 magnum long block out of a ram Speed master aluminum intake manifold 4160 Holley 750 Accel 8mm wires Accel 140001 coil Electric fuel pump Aluminum radiator with electric fan Hedman headers Aluminized 2.5" exhaust with true duals Stock suspension...

Can I still drive it to the transmission shop?

Mine started doing this today. Never disconnected the kickdown linkage and it is rigged correctly. I think when I went from 1st to 2nd while burning out is what caused it.

Thanks zk. This helps a lot.

If someone could measure the edge of the fenders from the center of the axle at 9, 12, and 3 o clock that would give me a start. I understand everyone's reasoning and opinions but I had a simple question and got 6 replies with no answer. I appreciate your inputs but I just want them off. Pretty...

So it rained a lot today but I got the car out for some burnouts. Still need those dimensions guys. Thanks

I think I will pass on the wheel/tire combo. I would however appreciate measurements for the fender well arch

Because I'm broke. You can donate them to me though

The

so the previous owner put bondo all over the rear fenders and made silly flares. I want to cut them off. Can someone measure their fenders so I have an idea. Thanks.

Actually I also found out that the trans linkage wasn't all the way forward and was hung up on the bulkhead harness connector

I will absolutely get pics. I just recently learned of the spring for the throttle rod. The Holley adapter 20-7 is installed

Sorry to hijack the thread but I am still lost. I have read a lot of posts and videos and I am still not getting it. I have a 360 with a 904 Holley 4160 and speed master air gap. I need pics of the adjustment or a video. That's just the way I learn and I don't want to mess this up. I need help...

What shape does it need to be in ? Mine has some bad fins and might need to be rodded

Looking for a shop near the coast new bern/Jacksonville nc area. Must be experienced with carbs and old cars. Recommendations accepted. Thanks

$30 free shipping

Compressor sold. Bracket, condensor, evaporator, hoses, drier, expansion valve still available. Make an offer

You are very wise