Search results for query: *

Had to put a dimple in one tube. But the steering is like a new car.

Thank you for getting back to me on the pulleys. I'm trying to make sure everything will line up with the a/c unit that I have. It is a classic auto air unit. The pulleys I have now are from march performance the front belt runs the a/c and p/s. The back belt fan and alt. All are single v,crank...

water pump pulley 2463332 dia 5 3/4, 2 3/4 deep . Crank #2536752.

looking for overdrive crank and water pump pulleys for 68 340 barracuda. Water pump outlet on drivers side. This is a after market a/c from classic air unit. Car runs cool when driving down the road but when it sits and idles temp goes up. I don't think it is pulling enough air with the under...

You need to check the distance I just bought a cold case with the electric fan and did not have enough distance for it to fit. You need at least 6 3/4 inches for it to fit or a little more had to send mine back to jegs.

I got the borgeson box and love it. I did cut 1/2" off my shaft but after I found out there is a coupling that will work with it so you don't have to cut the shaft. It is in one of the threads on here.

I will be at the car show at little d's sat- 5/04/19 come out and let's meet.

The only problem I had was one header pipe was hitting . I am running dougs headers 1 5/8. I tried to dent the header but was not able to. I put a 1/4" shim under the driver side motor mount it worked out fine. I love the gearbox like driving a new car.

Had the same problem with my 68 cuda . I checked everything under the car all was tight. Then tried to adjust the steering box no luck . Bit the bullit and got a borgeson box from summit. The car now drives like a new car.

Wonder how much porting they will take and what number you can get too.

My old box was loose and a handful to drive. With the borgeson box it's like driving a new car.

It's close but not hitting Yes, before I had to steer with one hand and move the steering wheel up and down. If you were on an uneven road it got to where it would dart. So I bit the bullet and went with the borgeson power steering box. I love it I can drive it with one finger on the wheel even...

I got my new borgeson steering box installed. It is like day and night in the handling. I jacked up motor on driver side and pulled old box out from the top after pulling the header. I had to shim the motor mount 1/4" to get some clearance with the dougs headers. Cut 3/4" off the steering shaft...

installed new borgeson power steering box. Driver side dougs header was hitting box. I shimmed motor mount 1/4 to get clearance. Any concerns with this? Thanks 53

Take a propane torch and heat the old pump where the fitting screws in and it should come out.

Someone had some for sale on here awhile back I bought some not stainless.

How about fenders for 68.

Looks good hope all goes well and it hits the numbers you are looking for. I hope it surprises you.

Got the motor running today sounds good. Friend who built it came over and we got it going. Fired right up.

Headed to rockingham.

See you there need some parts

Prayers sent

What is the cost of dyno time vs getting what you are looking for and being happy ?

need help putting fenders on my cuda. Which bolts and where do they go?

How did you set the car up to get everything level and plum?

Welcome from Florence SC . Post some pictures

wish AMD made front fenders for the 68 cuda.

Welcome from Florence South Carolina.

Welcome

Welcome to FABO