Search results for query: *

Anyone know where to get these, 1966 Dart? Thanks

What is the maximum distance the front of the fan should be from radiator for proper cooling? Or is there such a dimension? Thanks

What holds the cover behind the housing for the directionals to the steering column? Masking tape with arrow? Thanks

Won't keep me signed in. Thanks

Any recommendations for above, that is not junk? Thanks

Have any of you had any experience with their Hurricane Engine Driven Shrouds? Looking at using one on my 66 Dart Champion Radiator. Thanks

Anyone use this type of fan shroud? Thanks

Just started the car and was charging like normal 14 volts, then just quit and dropped to 12 volts. Any advice? Thanks

What is the correct length for these? I think either my tube is not the correct length or I have the wrong dipstick. The actual full line on the dipstick is 1 5/8" from the tip, which low after an oil change of 5 quarts. The tube is 11 inches to block and the dipstick is 20 1/2 inches to the cup...

How much fluctuation should an alternator have at idle? I am going to run it in my car disconnected from both the field and battery post, and check it with my multimeter. Thanks

!966 Dart, any recommendations for one of these? Thanks

I need at least one castle nut for the 2-10-61 shaft package lower control arm p/n 2275 461 1966 Dart. This is the shaft on the front side where the torsion bar goes. Thanks

Have any of you encountered fan noise at certain engine rpms when driving with a fixed 6 bladed fan? Thanks

Are there two different replacement tanks one 16, and the other 18 gallon? 1966 Dart. Thanks

What is the correct PCV grommet for above? The one I have keeps coming loose. Thanks

The seal between the front and rear windows. Are the seals available and are they hard to install? Thanks

Cancel

Does anyone have the full Borgeson setup with above headers in an early A body? If so were there any clearance issues? Thanks

Classiccars.com has this for sale if anyone was interested? Listing CC-1425992

Are the bushings a problem to change out? Thanks

What do you electrical guys think of these splices? I found some under the dash, I personally don't like them and thinking of taking them out. Thanks

Anyone know what this is for? Made out of plastic, on the wire harness left side of trunk under one of the factory harness support tabs. I don't think it is supposed to be there. Thanks

Anyone ever remove the male terminals from above? Looks like an impossible task. Thanks

Does anyone know the location of these? I am going to run my car prior to putting the instrument cluster back in and would like to shake them a little to see if they are solid. Thanks

Since I have my instrument cluster out, I was looking at lubricating my wiper linkage. Is Lubriplate a good choice? Thanks

What should the volts be in the sockets, I have 9volts in parking light position? Thanks

Anyone got any recommendations for cleaning spilled Ant-Freeze off of these? Thanks

Any shroud recommendations, 360 mechanical fan? Thanks

Just wondering, can the lock cylinder in the ignition switch cause any electrical issues? Thanks

1.On the wiring diagram for above, does anyone know what the Brown T2 12 gauge is for? 2.The car never had the Accessory Circuit Breaker or the Q1 12 gage red with tracer, does it matter? Thanks