Search results for query: *

  1. B

    No Spark while Cranking. Engine starts when key is let go.

    You guys are the best. :toothy10: All of the info was on target. It was the switch. I had power at the coil and on both sides of the ballast with the key on but i could not test the voltage by myself with the key turned. I took out the switch and tested for continuity on the bench and i had...
  3. B

    No Spark while Cranking. Engine starts when key is let go.

    1967 273-4 automatic I crank the engine over and i get no spark but as i let the key go the engine will start. What is the deal? I have changed the starter relay and control box but it did not help. Any suggestions ? Thanks
  4. B

    Broke the exhaust stud then the extractor what now?

    Thanks for the ideas and well wishes. Slotting the extractor with a dremel is a good idea and i will try that first. If the extractor piece comes out i will be happier. Back in the garage with another project i didn't plan on. What a mess. I just can't believe the trouble this is going to...
  5. B

    Broke the exhaust stud then the extractor what now?

    Thanks for the welcome Mullinax. I was hoping for some better news than that but i think you may be right!
  6. B

    Broke the exhaust stud then the extractor what now?

    I was trying to remove the passenger side rear exhaust stud and i broke it off flush with the engine. I then drilled it out, inserted the extractor, turned a few times and it broke off inside the hole!!!!! WTF!!! Unbelievable!!!!!! I tried to re-drill the hole but the piece of the tool that...
  8. 67 Convertible Barracuda 273-4

    67 Convertible Barracuda 273-4

    I bought it as a project/driver. It had an old 318 installed and running poorly. It also had the original engine in the trunk and back seat. It was very complete and it had been on the road last in San Diego in 1997. I found the build sheet under the back seat, Certicard in the engine...
Back
Top