Search results for query: *

Excellent condition. Free for pick up. Yorba Linda, CA.

Free! Just pick them up. Front buckets and rear bench. The buckets were recently re-covered. Excellent condition. Yorba Linda CA.

I know I can measure, but does anyone have a part number or belt size to use when eliminating A/C on a Hellcat motor?

I'm running a mechanical boost gauge. Outside of taking the SC apart, drilling and tapping, is there and access port or aftermarket part to attach the line?

I'm running -8 AN fuel lines. How do I connect to the fuel rail?

Is there a name/size/type for the fittings on a stock Dodge Hellcat oil cooler? I need to convert to AN.

Starting on a new project. After selling the 64 Valiant, I bought a freshly restored 1967 Barracuda. Going to tear it all down (except the exterior paint), make some cool mods and swap in all new Hellcat motor and 8 speed HP90 transmission.

Having trouble installing the window seal at the rear quarter window area. The seal has the same form all the way around but the trim piece is completely different. Is it a separate piece? See pics below.

Does anyone know which line (passenger or driver side)feeds the heater core on a 6.4. Running an after market A/C Heater unit that uses a bypass valve.

Need a set of tail light bezel/body gaskets for a 1964 Plymouth Valiant.

Any idea when these will be in production?

Talking with Vintage Air; They say not to use the factory LS type compressor (it's a variable displacement) and to use a Sanden type (fixed displacement). I'm cool with that but need to know where to find a bracket for the conversion or is there a Sanden unit that is a direct replacement?

I'm running an after market tank and fuel pump. Stock motor, factory EFI. The fuel pump is rated at 100PSI, 400LPH. What fuel regulator do I use?

Bought a clean 1964 Plymouth Valiant HT a few months ago. Bought a 6.4L Hemi with NAG1 trans. Going to attempt to install motor and trans and perform a few other mods. Apologies in advance to those whose magnificent ideas I've stolen from these forums.

I need to know exactly how to wire in the single wire neutral safety switch to a standard automotive relay. The wiring has been done from scratch and the old MOPAR relay is gone. I have: an ignition start wire, the NSS wire, and a wire that goes from the relay to the small post on the starter...

I am installing all new wiring on a 67 Dart. I am using a universal kit. I need to adapt the kit to the OEM connection at the column. Does anyone know what each colored wire on the OEM harness does? I have a schematic but was looking for some simple color codes. I have figured out most...

I am installing universal wiring harness and need to adapt to OEM headlight switch. Anyone know what each terminal on the switch is dedicated to. Where do they go?

I am running a battery shut off switch. Sometimes the car will sit for awhile and I'd like to eliminate battery drain. I would like to run a 5A fused, dedicated line from the + terminal on the switch to the radio (memory). If I do this I will have feed back back thru the line, keeping the...

I have been using a B & M Hammer shifter for the last few months. I can no longer get it into reverse or park. Only the ratchet function works on the forward gears. It's not the trans as the cable is disconnected. The detent seems to be working just by eye balling it. I would have no...

I just installed a trans temp gauge. What is the normal operating temp for a 727?