Search results for query: *

  • Users: 70 DDDart
  • Content: Threads
  • Order by date
  1. 7

    Lower Control Arm Pivot Bushing

    So I scanned this topic and although I might of missed it I did not see anything in FABO that addresses my question. Recently I was rebuilding my entire front suspension, in the process I was doing the upper CA bushings , replaced them with Energy Suspension urethane pieces. I had looked at the...
  2. 7

    1970 Factory Rally tach

    What is the factory tach "zero" position for 1970 Rally dash...... 5 oclock or 8 oclock
  3. 7

    408 6 pack carb jetting

    Just got my new 408 stroker assembled and I am going to run the LA six pack set up so was wondering if anyone out there has a carb tune for this setup? Specifically,What jet size for ctre carb and what vacuum spring color for the out boards? The stroker has MP flat tappet 508 lift cam, about...
  4. 7

    Speedo Gears

    I am running 255 x 60-15" BFG's on rear with 391 SG gears with A 833 4 speed. My FSM chart does not list P- metric sizing because it is for 1971 cars. There is not enough reliable info on the internet to convert the tire size. It looks like a 39 tooth gear should be close to correct my...
  5. 7

    Orange Box

    On my wiring instruction sheet for an Orange Box install the green wire (with red tracer) says "not used" . Does anyone know what it is for or even why it is there? Perchance tach drive???
  6. 7

    Alternate Oil Filter

    Not sure if this is the right catagory for this new member and have never done anything like this before. Anyway my problem is that I cannot remove or replace my PH 43 oil filter! The problem is there is not enough room between the header (TTI Step) and my Lakewood bell housing because of the...
  7. 7

    Introduction

    Hi been visiting the site for some time now and finally decided to join. Never hurts to have many heads working on a problem. I have a 70 S that I have '70 Swinger that I have owned for more than 40 years and has been a project that I finally decided to finish a couple of years ago. It has a...
Back
Top