Search results for query: *

I installed pertronix hp ignition box and flamethrower 3 coil. Now i dont have spark. I get power to box and its plinking Green when cranking. I have measured switched power is ok and main power and ground are on battery. Should there be voltage at coil +? I dont

hello! so this is prob stupid guestion but can i change springs in my distributor and add limiter plate while distributor is in car or do i have to remove it.ty :=) car has -70 sbm

I have low vacuum from engine because cam, brakes are hard when first starting to drive the car. What do you suggest i do for my power brakes? I have looked at leed`s vacuum pump but is there anything else *** good but not so pricey.

Hello. Im thinking deleting my ballast resistor because im planning going to holley sniper. I like to know if my current ballast is wired correctly and can i just wire the poles together and get 12v switched from that. I know i need new coil that dosent require ballast but can the mopar Orange...

So i have 904 transmission with lokar kickdown cabble. Problem is the trans kickdown lever dosent fully go back when i let off thortle. if i crawl under the car i can push the lever like half inc towards the engine. Im thinking of adding spring to lever. but should kickdown lever be completly...

okey specs for car first. dart 71 318 scat i-beams kb flat top pistons comp cams nostalgia plus pn#20-670-20 int.dur.adv 280 exh.dur.adv 287 exh. valve lift 0.474 int. valve lift 0.474 speedermaster intake edelbrock 1405 carb mopar elec ign vac advence is disconnect and base timing is about 20...

So i just bought 71dart. the fuel and temp gauge dosent work. oil pressure light works and some of the cluster instrument lights work like turn signal light. i have alredy taken the cluster out and cleaned circuit board from corrosion and i did verify that the meters work with battery charger...