Search results for query: *

I'm more like too late, but most modern alignment equipment has specs back to 1950s. I had my 68 barracuda aligned and the computer on the machine had the specs and the job was done routinely. good luck.

Thanks for the input to date. The problem of this installation is the interior was redone about 18 months ago. That would have been the best time to install if possible. Your are right about the rear side panels, mine are not great but have not found any better in over two years of looking.

Has anyone installed 3-point seat belts in a 68 barracuda conv? My wife feels unsafe riding with only a lap belt. I would like to install 3-point belt but can not find a good place for the shoulder belt anchor bolt.:read2:

Has anyone installed 3-point seat belts in a 68 barracuda conv. My wife feels unsafe riding with just a lap belt. I would like to install 3-point belts but can not find a good place to mount the shoulder belt anchor bolt. any suggestions? :read2:

i have never changed a fuel sending unit and have the following questions for all you pros at forabodiesonly. 1 Are there any unusual tool required? 2 What are the possible pitfalls associated with a rusty old unit being removed? 3 How is the new unit sealed to prevent leakage, gasket, o-rings...

Thanks for the tip.

I want to install an after market fuel level gauge, but do not know what the sending unit ohm ratings are for a 68 barracuda (318). The gauge must match the sending unit to work correctly. Since to car is in storage for the winter with a full tank of gas, getting reading from the installed...