Search results for query: *

  1. L

    Purple Shaft vs XE Comp Cam

    I don't have a lot to compare it to, but with the 904 behind it it really was strong from bottom to top. It comes on best over 2K though and will pull hard all the way up. I don't have a really good feel for the entire range because i've been fighting transmission woes, and have been finishing...
  3. L

    Purple Shaft vs XE Comp Cam

    I'm running the XE275HL in my 360. .525 lift on both sides, but not a wild duration (231/237 @ .050). Streetable all day long, not an issue at all. I believe the HL series also takes advantage of the wider lobe area that the mopar smallblocks offer, allowing for better life on the street with...
  4. L

    Need a steel 318 Crank. Where to buy?

    It's too bad you aren't in Oregon. I have one sitting in my garage that I was going to use until I learned that my 318 block was no good.
  5. L

    Header Bolts ???

    I believe the back bolts are wet. If it's an LA motor with LA heads. I switched over to Magnum heads and have not had them leak water when changing header gaskets, so I'm not sure if the magnum heads are wet, but I know that the LA heads were.
  6. L

    90 Deg Oil Filter Adapter Torque Spec?

    Also, It may make a difference as to what adapter you are using. I don't know about the aluminum one. And i'm not sure why it's not in the gasket kit. My kit came with a new bolt, the large gasket, and then the two small ones, one for each end of the bolt.
  8. L

    90 Deg Oil Filter Adapter Torque Spec?

    Mine had the gasket for the adapter to the block, and then two others; a thin metal gasket that went underneath the bolt head and one that went on the other end of the bolt (between the block and the center of the adapter). This last one was a thicker, clear/white plastic washer (not hard...
  9. L

    90 Deg Oil Filter Adapter Torque Spec?

    The paperwork that came with my new bolt and gasket set said 50 ft/lbs. After I torqued it, though, a lot of people told me to be careful, as the bolts are easy to break. everyone also said they don't need to be any tighter than you would tighten your oil filter. Luckily, mine didn't break, and...
  10. L

    bad vibrations

    Are you sure the vibration is with the motor? Do you still notice the vibration at low rpm when the car is sitting? or only when driving? If it's only when driving, you may be looking at something else, tranny?
Back
Top