Search results for query: *

1.5" blocks in the back, torsion bars turned down to match up front. 245/45 on 17x8 up front 275/40 on 17x8 in the rear

I may have found the culprit. My measurements are as follows: A (right): 13.75" B (left): 16.25" C (K-frame): 4.5" Looks like my motor is sitting low. I'm assuming the biscuit mounts are a little on the thin side?

Thanks for the attachment Tom, much appreciated. I'll check to make sure I positioned the engine/trans properly then go from there.

Also, I installed new motor mounts, Anchor Industries, part no. 2266... http://www.summitracing.com/parts/ani-2266

Morning all, here's my situation... First of all this is all in my 69 barracuda, I've got a factory small block K-frame that my 318 rests on, Edelbrock aluminum heads, Doug's Headers, mini starter and a set of 1" Just Suspension torsion bars. I dropped the motor & trans back in the car...