Good. I suppose I can can start looking around for half-used tubes instead of full ones. I used 3/4 of a tube on the last one I did. Maybe I did it WRONG, but it didn't leak.
Don't know about plenty at Napa. I bought the only tube left in a store within 250 miles. Memphis hub had one tube left...
I've been trying to locate this stuff everywhere I know to look and just everyone that carries it is either out or almost out. I ordered 2 from NPD and they emailed me and only had one. What gives? Is 3M withdrawing this from the market? If that's the case what is an acceptable, PROVEN...
Hey guys:
I'm putting together my latest cheap 4-door beater, this one a '69 Dart Custom with the wide side molding down the center. I scabbed on a quarter section to replace wreck damage. In the collision I assume the original piece of trim between the rear door and the end of the rear...
Here is an original 1968 Valiant in Turbine Bronze. It looks more brown because of aging, but it's a very attractive color. This may be the only known picture of a Valiant in this color. Seen a few Darts but not many. The Dart Sport is not Turbine Bronze. It looks like it but it's a darker K6...
Glazing putty...that makes a lot of sense. Finally someone has verified that I'm not making something up. People are such information repeaters without even knowing what they are talking about.
This is directly from the 1969 Dodge service manual regarding windshield installation:
Installation...
Thank you, but not according to what I've found. I am very familiar with bedding compound...I also have a tube of it on hand and used most of that tube on the last windshield. To offer additional clarity, I have prepared further photographic evidence:
In the top photograph, you see the mystery...
Hey guys:
I'm taking on the unenviable task of cleaning up a windshield channel again and encountered something I needed to ask about. Below in the first picture is the windshield channel on my '69. I spent well over an hour cleaning out the sealant along (half of) the bottom, where the...
Hey guys:
I was wondering if the flocked, rubber guides that the door glass slides up and down in are available anywhere new for a 4dr sedan? How do you remove and replace? I read through the FSM but it's not clear with all the models being jammed together. I'm thinking the pieces for a 2dr...
Hey guys:
The rear of the hood on my Sport stays popped up a couple inches whenever I close it. I can push each rear corner down by hand and then the hood sits flush.
What's behind this...dry hinges?Adjustment? There's no damage to the front of the car.
Thanks.
Hey guys:
Finally have a car with nice southwestern floors, and I'd like to know what the most viable material coating seems to be as far as moisture proofing, wear and appearance factors are concerned.
I have factory red floors and I'm not too crazy about applying a black or grey coating. Thanks.
Hey guys:
A fellow member would like to purchase one of my pair of late front inner fender splash shields. It's been a long time since I pulled them and don't recall which one is left and right.
Here's a photo if someone could clue me in. Thanks!
Hey guys:
I just picked up a clean '74, and it's leaking water around the taillights into the trunk, and might even be leaking into the lights themselves.
It's caused some rust, so I'd like to reseal those things SOON. What are my options?
Thanks...
Hey guys:
When I rolled the driver's window up in my '71 Valiant today, it dropped into the door and stayed there, lol. Luckily it didn't break.
Before I tear into it, is there anything known to cause this and anything to prevent it again...