Here is a nice 1407 Edelbrock 750,works & looks great,I bought this new,the only thing I ever did to it was to add an electric choke,it is still on the car so if you are local (Neenah,Wi) you can hear it run,just bolt it on & go.$165 shipped in lower 48
These will fit a B engine in an A body with minor mods (see thread in big block section for photo), they are in nice condition, heat riser spring is bad, casting #'s are 2899879 & 2951216. $300 shipped in lower 48.
1967 273 ci 2 barrel solid lifter V8 with a 904 auto trans from my '67 Dodge Coronet,starts, runs & shifts good,it does use some oil but it doesn't seem to smoke,still in car so you can hear it run & take it down the road.Its been my daily driver all summer & I've driven it from California to...
A set of pistons from a Chrysler Marine 340, look to have little use, for standard 4.040" bore, $35.00 shipped to lower 48, also have a set of rods from a '73 340,motor was virgin, with no spun bearings, good cores but dirty, $40.00 shipped.
3 Mickey Thomson valve covers to fit big blocks,lightly glass beaded,in good shape,missing baffles & grommets,could use a good cleaning,$60.00 shipped to lower 48.
I have a complete drum to drum 8 3/4" rear from a '70 340 Swinger,741 case,3.23 open diff,sbp axles,also have the shock mount plates to go with it.The housing is not rusty or pitted. $700,located in Neenah,Wi.
I could use a passenger side fresh air vent box assembly for my heater delete '66 Valiant,it was removed & replaced with a heater by the selling dealer when it was a new car.
Here is a NOS (not a reman!) Carter AFB to fit a 1967 273 Commando/Charger V8 with manual trans & California emissions or CAP. It is stamped A3 4304S.It's in new condition with no corrosion or tarnishing of any kind.Has choke pull off & dashpot.Perfect for a concourse restoration.Price is $350...
These were on my '69 318 Barracuda,it was for a Sears A/C system,should fit all '69 & older small block with the iron water pump,free if you pick it up,$20.00 shipped in lower 48.I also have the cast iron 3 groove crank pulley that you can have but I would need the proper steel 2 groove pulley...