Search results for query: *

I've got a door sitting in the back, drivers side. I will see if it's the same as what you're after.

I'll PM you

This is what I have inside. There is a pair of them in a bumper outside, but it's been outside without lenses in it a long time. If these are any use to you, let me know.

Sorry about that, the ones I have inside have somewhat corroded bulb sockets. I have another set but they're outside and they're most likely in the same condition. I will try to get pictures today and you can tell me if you think they're worth it.

I've got this Flaming River joint, it was in my '70 Dart. For power column to manual box.

I'll take a look out back today, I think I have a few of them.

I think I've got those, I will take a look today.

I've got hinge covers.

I have a pair from a '68 Barracuda 340.

I believe I have some, I will check tomorrow.

I have them, I will get you a picture tomorrow.

Yes, that's the engine I have. The numbers decode to it being from a '56 Chrysler 300B, with the 10:1 pistons. I contacted Egge, they are only producing the lower compression pistons right now, and Hot Heads said they are only selling those ones.

Did you get a chance to look for those pistons?

Thanks!

I'm looking for a set of standard bore 354 Hemi pistons, anyone have anything? I'm preferably looking for the taller, higher compression pistons, that measure 1.95" from center of wrist pin to the top of piston. Quite honestly, if you just had a partial set, I would buy that too. The lower...

I have the interior parts around the back window in black.

I've got a few of those as well if you still need one.

Wanted : 1962 - 65 A body speedometer cable Must be like the one pictured, with the one end that just presses into the transmission. If yours has 2 threaded ends, it's not the one I want. Thanks!

To clarify.. it's a '65 Valiant with a 4 bbl 318 and 4 speed. No kickdown needed.

Wanted: 1965 A body V8 gas pedal and linkage, all the way to the carb. I need all the hardware, brackets, everything to put a V8 pedal with linkage in my '65 Valiant. Thanks

Wanted : '65 Valiant front turn signal lenses, mine aren't great. Also need the turn signal lever, mine is quite rusty. Anyone?

Shows what I know! LOL. Well, the "dipstick" tube that is there, sure looks odd to me. I guess I should look at the 440 in my '63 Dodge W300 and see how it looks.

I've got those! I'll get you a pic. The only thing is someone drilled and tapped the side for a funky dipstick tube setup. I'd just weld that shut.

I have a few, I'm on Vancouver Island in BC.

Not sure if you use facebook, but there is a group on there called Fish Tales 67 - 69 Barracuda, and a fellow named Mike Boyd who was going to scrap a fastback shell that is absolutely gorgeous rust free! He's offering it up before it goes .

I've got one.

Here you go. Scroll down a few posts to the picture with the yellow hood. http://www.forabodiesonly.com/mopar/showthread.php?t=244183

What year Dart?

I'm redoing a dash from a '68 Barracuda and I need the ash tray, this one is missing. Color isn't important, but it needs to be from a '68. It's 5" wide, whereas a '67 is 6" wide. I'm unsure on '69s. Please PM me with what you have. Thanks, Mike

So that would be the same as 4 door trim, since yours is considered a sedan? If so I think I've got a couple sets. Where are you located? I'm on Vancouver Island in BC.