Search results for query: *

Built 383 long block with Edelbrock RPM heads, torker intake, .060 forged Jahns aluminum pistons (around 11:1 static compression), polished stock forged rods, stock forged crank, ARP bolts, comp XE-284H-10 cam, comp pro magnum roller rockers. Engine has never been fired, but well oiled and...

That’s fine, I’m in no rush. If any of them match the magnum fuel rail spacing, I’ll buy that one. If none of them match, I’ll take either the m1 or the Holley

Would you mind measuring the spacing for me? I’ve got a magnum fuel rail laying here that I can measure for comparison

And do you know if the injector spacing is the same as the magnum engines factory injector spacing?

And it’s hard to tell in that photo but is the Holley a street dominator or strip dominator?

Yes, they made the m1 in both single and dual plane. Are they both 340/360 size ports?

Which model Edelbrock is that? And which Mopar intake?

Hold downs and spacers sold. $40 plus shipping for the shafts.

Ok. Upgraded to gold. Got plenty of room now.

Should be some room there now.

Idk if it was worth saving these or not, but figured I’d throw them up here to see if anyone can use them. I pulled these adjuster screws and jam nuts out of a junk set of small block aluminum rocker arms. Threads all look very good. $20 shipped anywhere in the lower 48.

I have a set of aftermarket small block rocker shafts and hold downs. $50 plus shipping from 42256

PM sent

Third

Torker

Here’s the pistons that were used. Need help identifying pistons (Jahns) Should be around 11:1 static compression.

I’ll have to get that when I go pick up the parts this weekend

I have a big block 727 transmission available. I bought it in a parts lot and don’t know anything about it, consider it a core. $300 I’ll be traveling from Houston, Tx to Russellville, Ky December 18-19th and can meet/deliver along the way.

Built 383 long block with Edelbrock RPM heads, forged Jahns aluminum pistons, polished stock forged rods, stock forged crank, ARP bolts, comp XE-284H-10 cam, comp pro magnum roller rockers. Engine has never been fired, but well oiled and sealed. $4500 I’ll be traveling from Houston, Tx to...

Ok. I’ll send you a pm.

Finally got a measurement off my hood today. From left to right, looks like 3 3/4” from center of 1st hole to center of 2nd and 8 1/4” from center of first hole to center of 3rd hole.

Ok sounds good. I’ll see if I can measure the spacing for the holes in my hood tomorrow and go from there. Thanks

Is the Plymouth lettering for a Duster/valiant hood or trunk?

I’ll take it if it falls through.

$125 + shipping

Sale pending

I have a cast Mopar Performance air cleaner lid and base for sale. I bought these a few years ago and never got around to installing them. They sat in storage, covered in dust and the paint started to bubble and come off in a few spots and two of the ribs have a groove in them where a hood...

I have a Super Six carb (everything moves freely but needs rebuilt), air cleaner and stove pipe. $150 + shipping from 42256

*EDIT* Wiper motor harness has been sold. I have a engine/front light harness from a 72 valiant. The harness is in excellent condition. Asking $60 plus shipping from 42256 Thanks.

I have a complete (minus kickdown linkage) super 6 setup I got with a 79 Aspen a few years ago. The carburetor I’m sure will need rebuilt from sitting and the shafts seem to be gummed up some. As can be seen in the photos, someone welded up a couple cracks on the exhaust manifold. I can can...